Page 6
HOW TO USE
Do not use the product to cook raw meats, fish or poultry. This product is
designed for heating liquids/pre-cooked foods and is not intended for cooking
raw foods.
Do not use this product to heat butter or oil.
CAUTION: Heating of foods such as spaghetti sauce, chili or other tomato-based
products is not recommended, as they could permanently stain the product.
1. Clean the product thoroughly before use, following the cleaning instructions
in the “Care and Maintenance” section.
2. Place the product on a flat, stable, heat and water-resistant surface.
3. Ensure the product is unplugged from the electrical outlet and the Control
Knob is at the “Low” position.
4. Add the contents to be heated into the product, ensuring that the products
stays level while adding contents.
WARNING: Do not fill above the “MAX” line or below the “MIN” line indicated
inside the product, and do not operate the product when it is empty.
5. Fully close the Lid and then plug the product into a standard electrical outlet.
TIP: To heat milk and canned/pre-cooked foods (e.g. soups, sauces,
canned vegetables, etc.), set the Control Knob to a low setting and
frequently stir contents to prevent burning, sticking, and boiling over.
7. When contents are heated to the desired level, turn the Control Knob to
the “Low” position and then unplug the product.
NOTE: A slight odor may be emitted during the first few uses of the product;
this is normal.
6. Set the Control Knob to the desired position.
STEAMING:
1. Place the product on a flat, stable, heat and water-resistant surface.
2. Ensure the product is unplugged from the electrical outlet and the Control
Knob is at the “Low” position.
3. Place the Steamer Rack into the product.
4. Pour fresh room-temperature water into the product making sure the water
does not rise pass the Steamer Rack.
5. Place food to be steamed onto the Steamer Rack.
6. Fully close the Lid and then plug the product into a standard electrical
outlet.
7. Set the Control Knob to the desired position.
8. When contents are steamed to the desired level, turn the Control Knob to
the “Low” position and then unplug the product.
WARNING: Do not allow the contents to evaporate as this may cause a
fire hazard. Always unplug the product from the electrical outlet when
it is not in use or will be left unattended.
