CUWIN V Series
CVW-070BR/CWV-070WR/CWV-102BR Hardware Manual
COMFILE Technology, Inc. www.comfiletech.com •page 4
Name Description
A Power input DC-Jack
φ2.5 DC Power Input Jack for adaptor
B Power terminal Power terminal for cables
C Power S/W Power input ON/OFF
D COM3 COM3 (RS232C / Female Type D-SUB 9PIN)
E COM2 COM2 (RS232C / Female Type D-SUB 9PIN)
F COM1_RS232C COM1_RS232C (RS232C / Female Type D-SUB 9PIN)
G COM1 Mode Switch DIP Switch for selecting COM1 mode
H COM1_RS485 COM1_RS485 Port (RS485)
I Ethernet 10Base-T Ethernet Port (RJ-45)
J USB_HOST USB Host Port (USB A Type Connector)
K USB_DEVICE USB OTG Port (USB mini AB Type Connector)
L SD Card Connector SD Card slot
M Audio Out StereoAudio Output Port (φ3.5)
N Boot Mode S/W DIP Switch for selecting Boot mode
3. Bracket Installation
Mounting screws and brackets are provided with each CUWIN. They are designed to clamp the
CUWIN bezel against a front panel, with the rear portion of the device extending through a panel
cutout.
After assembling the brackets as shown below, insert the side hooks into the appropriate mounting
holes on the top and bottom of the device.
Then tighten the screws enough to hold the CUWIN securely against the front panel. Do not over
tighten, or you will risk damaging the CUWIN.
