Comfort Company COMFORT FOOT User manual

WARNING: Make sure all screws are tightly clamped upon completion.
Toll Free 800.564.9248
www.comfortcompany.com
509 South 22nd Ave Bozeman, MT 59718
COMFORTFOOT_LIT016_12192012
COMFORT FOOT / SINGLE FOOT
1
2
3
4
Diagram 1 (steps 1-3) Diagram 2 (step 4)
Common Loop
Leg rest tube
Footplate
Clamp Wheelchair Footplate
A
B
Clamp On
Parts Included:
1 - Clamp Assembly
Loosen (do not remove) foot
plate clamp using Phillips head
screw driver.
Slide clamp over wheelchair foot
rest plate.
Adjust Comfort Foot to desired
position and tighten the screw
securely.
Release common loop and secure
tightly around leg rest tubing.
Depending on the wheelchair,
common loop will have to be
tightened around either position
(A) or (B) as seen in the diagram.
Diagram 2Diagram 1
Legrest Position
A
B
2.75”
Bolt On
Parts Included:
2 - ¼-20 x 1” or ¼-20 x 1 ¼ ” Screws (dimensions vary depending on size of part)
2 - ¼ ” x 1 ¼ " OD Fender Washer
1
2
3
4
Place template on the wheelchair
footplate in the desired position.
Drill two 5/16” diameter holes
through the footplate of the
wheelchair as marked on the
template.
Screw two ¼-20 x 1” or ¼-20 x
1¼ ” bolts (depending on thick-
ness of the footplate) with the
provided washers from the
bottom of the footplate into the
Molded Foot Base.
Release common loop and secure
tightly around leg rest tubing.
Depending on the wheelchair,
common loop will have to be
tightened around either position
(A) or (B) as seen in the diagram.

.
COMFORT FOOT
BOLT-ON TEMPLATE