Comfort Zone CZQTV007E Series User manual

Save These Instructions
www.comfortzoneproducts.com
Features:
• Adjustable Thermostat
• Three Heat Settings:
Energy Save Mode
Low: 750W
High: 1,500W (5,120 BTU)
• Top Mounted Electronic Control Panel
• Safety Overheat Protection
• Safety Tip-Over Protection
• Convenient Stay Cool Carry Handle
• 120V AC / 60Hz / 12.5A
CZQTV007E Series
Quartz Tower Heater
ENERGY SAVE TECHNOLOGY®
helps save energy and reduces
your heating costs.
ENERGY SAVE TECHNOLOGY
provides comfortable heating
using 30% less energy than a
standard heater!*
*Note: Compared to a 1,500 watt space
heater on high heat.
Patent Pending

2
2
INTENDED USE:
This product is intended for indoor residential and ofce use only,
not for industrial or other commercial application. Use only with
electrical wiring that is in good working order and that meets
applicable codes and ordinances. This heater must be plugged
in to a 120V AC, 15 Amp (or larger) circuit. Do not plug anything
additional into the same circuit. If you have any questions
whether your wiring is adequate, consult a qualied electrician.
Risk of re, overheating, malfunction, property damage, injury or
even death may result if not adhered to.
Use your heater only with a working smoke detector located in
the vicinity of your heater.
While using your heater, you should follow the IMPORTANT
INSTRUCTIONS listed below. As part of those instructions, we
have used the word “WARNING” to indicate the level of hazard:
WARNING indicates a hazard which, if not avoided, could result
in injury or death.
IMPORTANT INSTRUCTIONS
When using electrical appliances, basic safety precautions should always
be followed to reduce the risk of re, electric shock and injury to persons,
including the following:
• Read all the instructions before using this heater.
• This heater is hot when in use. To avoid burns, do not let bare skin
touch hot surfaces. Use provided handle when moving this heater. Keep
combustible materials, such as furniture, pillows, bedding, papers,
clothes and curtains at least 3 feet (0.9 meters) from the front of the
heater and keep them away from the sides and rear.
• Do not use heater unattended. Use of extreme caution is necessary
when any heater is used by or near children, invalids, disabled persons
or pets.
• Do not operate the heater with a damaged power cord or after the
heater malfunctions, has been dropped or damaged in any manner.
Return heater to authorized service facility for examination, electrical or
mechanical adjustment or repair.
• Do not use heater outdoors
• Use your heater only in dry environments. This heater is not intended
for use in a bathroom, laundry area, or similar locations, or near sinks,
washing machines, swimming pools or other sources of water. Never
locate heater where it may fall into a bathtub or other water container.
Do not use in damp environments such as ooded basements.
• Do not place the heater on a small, unlevel, uneven or any surface which
might allow heater to tip or fall.
• For proper operation, heater should be placed on a smooth,
non-combustible, level surface. Do not place on rugs, carpet, vinyl
ooring or other plastic surfaces. Not for use outdoors or in wet areas.
• This heater is not designed as a primary heat source.
• Always plug heaters directly into a wall outlet/receptacle. Never use with
an extension cord or relocatable power tap (outlet/power strip). Always
unplug heater when not in use.
• Do not run power cord under carpeting. Do not cover cord with throw
rugs, runners or similar coverings. Arrange cord away from trafc area
where it will not be tripped over.
• To disconnect heater, turn controls off then remove plug from outlet.
• Do not insert or allow foreign objects to enter any ventilation or exhaust
opening as this may cause an electric shock or re or damage the heater.
• To prevent a possible re, do not block air intakes or exhaust in any
manner. Do not use on soft surfaces like a bed, where openings may
become blocked.
• A heater has hot and arcing or sparking parts inside. Do not use it in
areas where gasoline, paint or ammable liquids are used or stored.
• Use this heater only as described in this manual. Any other use not
recommended by the manufacturer may cause re, electric shock
or injury to persons or property.
READ & SAVE THESE
INSTRUCTIONS
WARNING: SHOCK HAZARD
Use your heater only in dry environments. This heater is
not intended for use in a bathroom, laundry area, or similar
locations, or near sinks, washing machines, swimming pools
or other sources of water. Never locate heater where it may fall
into a bathtub or other water receptacle. Do not use in damp
environments such as ooded basements.
WARNING: HOT SURFACES
Do not touch body of heater when in use. This heater is hot when
in use, to avoid burns, do not let bare skin touch hot surfaces. If
provided, use handles when moving this heater.
WARNING: FIRE HAZARD
Heater has hot and arcing or sparking parts inside. Do not use
near combustible materials or ammable gases or sources of
heat. DO NOT USE in areas where gasoline, paint or ammable
materials are used or stored. Keep combustible materials such
as furniture, pillows, bedding, papers, clothes and curtains at
least 3 feet (0.9 m) from the front of the heater and keep them
away from the sides and rear. To prevent a possible re, do not
block air intakes or exhaust in any manner. Do not use on soft
surfaces, like a bed, where openings may become blocked. Do
not place the heater near a bed because objects such as pillows
or blankets can fall off the bed and be ignited by the heater.
Do not insert or allow foreign objects to enter any ventilation or
exhaust opening as this may cause an electric shock, re, or
damage the heater.
WARNING: ELECTRICAL SHOCK HAZARD
Do not use with damaged cord or plug. Use with adequate
electrical system that is up to code.
CAUTION: TO PREVENT ELECTRIC SHOCK
This product has a polarized two prong plug (one blade is
wider than the other) that must be fully inserted into a matching
properly grounded outlet. This plug is designed to t a polarized
outlet only one way. If the plug does not t fully into the outlet,
reverse the plug. If the plug still does not t, contact a qualied
electrician. Do not attempt to defeat this safety feature.
Do not operate any heater with a damaged cord or plug or after
heater malfunctions, has been dropped or damaged in any
manner. Do not operate heater with a broken heating element
or ceramic cone or any visual imperfections. Disconnect power
before servicing. For repairs covered under warranty, see
warranty statement. For all other repairs contact Comfort Zone®
Customer Service by telephone or mail for information and
assistance.
PET OWNERS NOTE:
The health of birds and some small pets are extremely
sensitive to the fumes given off during the initial use of many
appliances. Although these fumes are not harmful to humans, it
is recommended that this heater not be used around birds and
small pets during its initial use until the manufacturing corrosion
coatings burn off.

3
3
USAGE:
HEATER OPERATION: Always operate the heater in the upright
position following all instructions and recommendations listed
in this manual.
HEATER LOCATION: Place the heater in the area of the room
that is coldest.
HEATER CONNECTION: Plug heater directly into 120 Volt AC,
60Hz wall outlet. Be sure plug ts tightly in outlet. A loose
connection may cause overheating and damage to the plug
or heater.
NOTE: To prevent overloading a circuit, do not plug the heater
into a circuit that is servicing other electrical needs.
TURNING HEATER ON: To start the heater, plug into an outlet.
The Power Indicator light will light up to indicate there is power
available. (During the heaters initial use, you may experience a
slight odor or smoking. This is the result of the heating element
lubrication “burning off.” This is normal and will go away after a
few minutes of use.)
POWER LEVEL CONTROL PANEL: This heater has 3 heat
settings: LOW, HIGH and ENERGY SAVE. Select the heat setting
that best meets your heating needs. The ENERGY SAVE setting
provides comfortable heating in most rooms, while saving you
money on energy costs. To adjust the heat settings:
HEAT SETTINGS:
a. Press the POWER button once for LOW heat.
The light under the will illuminate.
b. Press the POWER button a second time for
HIGH heat. The light under the will stay illuminated.
c. Press the POWER button a third time and the heater
will shut OFF. After the fan shuts off, the POWER indicator
light will turn ON again.
NOTE: When the unit is powered off, the fan may continue to run
for a while to cool off the ceramic elements and dispense any
retained heat. The unit will shut off automatically. Heater should
be unplugged when not in use.
ENERGY SAVE MODE:
a. Press the ENERGY SAVE button to turn the
ENERGY SAVE mode on. The ENERGY SAVE indicator
light will illuminate and the temperature lights will turn OFF.
The thermostat temperature will automatically change
to 68°F.
If the room temperature goes BELOW 60°F, the heater
will turn on in HIGH heat mode.
If the room temperature is between 60°F and 68°F, the
heater will turn on in LOW heat mode.
If the room temperature is ABOVE 68°F, the heater will go
into STANDBY mode. The POWER button will ash ON
and OFF repeatedly and the fan and heating elements will
turn OFF. The heater will exit STANDBY mode only if the
room temperature drops BELOW thermostat temperature.
b. To exit ENERGY SAVE mode, press any button.
THERMOSTAT ADJUSTMENT:
a. When the heater is in LOW or HIGH heat mode, press
the THERMOSTAT button until your desired
temperature is illuminated.
b. The temperature setting can be adjusted between
60°F and 80°F. The thermostat will automatically adjust
to the temperature you have selected.
If the room temperature is BELOW the thermostat setting,
the heater will turn ON at the selected heat setting.
If the room temperature is ABOVE the thermostat setting,
the heater will go into STANDBY mode.
NOTE: It is normal for the heater unit to cycle Heating On
and Heating Off as it maintains the set temperature.
TURNING OFF:
To turn the heater OFF, press the Power Button before
unplugging the heater. When not in use and unplugged, all lights
will remain off. Heater should be unplugged when not in use.
QUARTZ TUBES: Do not use with either quartz tube cracked
or broken.
Low Heat
Indicator
Power
Mode
Energy Save
Mode
Thermostat
High Heat
Indicator
Temperature
Indicator
Power
Indicator
Energy
Save
Indicator
CONTROL PANEL

4
4
LIMITED WARRANTY
This unit is guaranteed to the original retail purchaser
against defects in quality or workmanship for a period
of one year from the date of original purchase. If this unit
fails because of a manufacturing defect within 30 days of
purchase, return the unit, with your receipt, to the retailer.
After 30 days, but within the warranty period, if the unit
was purchased within the continental United States,
return it, freight prepaid, to World and Main for repair
or replacement. If the unit was purchased outside the
continental United States, return the unit to the place of
purchase. This warranty does not cover damage caused
by misuse, abuse, overheating or alteration. Repairs made
by anyone other than World and Main are not covered in
this warranty. World and Main will not be held liable for any
losses due to neglectful operation. All implied warranties,
including the warranties of merchantability and of tness of
purpose, if applicable, are hereby limited in duration to the
period of one year from the date of original retail purchase.
Some states do not allow limitations on how long an
implied warranty lasts, so the above limitations may not
apply to you. Incidental or consequential damages arising
from a breach of either express or implied warranties are
hereby disclaimed and excluded. Some states do
not allow the exclusion of limitation of incidental or
consequential damages, so this limitation or exclusion may
not apply to you. Upon the expiration of this warranty
all such liability will terminate. No other warranties are
expressed or implied.
This warranty gives you specic legal rights, and you may
also have other rights which vary from state to state.
No informal dispute settlement mechanisms are available.
This limited warranty is given in lieu of all other warranties.
Manufactured for:
World and Main (Cranbury), LLC
324A Half Acre Rd.
Cranbury, NJ 08512 USA
800-221-6895
www.comfortzoneproducts.com
Rev. 06/01/2022
IMPORTANT SAFETY FEATURES:
The heater is equipped with an automatic overheat protection
device located inside the body of the heater. If the heater grille
is obstructed, or if the heater gets too hot for any reason, the
automatic overheat protection device will turn the heater off. To
reset the heater, simply turn power off and unplug the heater
for 10 minutes until it cools down and then you may plug the
heater in and restart. Be sure that the heater is on a smooth level
surface with no obstructions. The heater is also equipped with
a safety tip-over switch to turn power off to the heater when the
heater tips over. To resume heater functions simply stand heater
upright.
CARE AND MAINTENANCE:
WARNING: ALWAYS UNPLUG THE CORD BEFORE MOVING
OR SERVICING. Do not use harsh chemical or abrasive cleaners.
DO NOT IMMERSE THE HEATER IN WATER. Allow heater to dry
completely before use.
CLEANING: IMPORTANT! DO NOT IMMERSE HEATER IN
WATER! Clean the heater grille with the vacuum brush
attachment on your vacuum cleaner. This will remove lint and
dirt from inside the heater. DO NOT ATTEMPT TO TAKE APART
THE HEATER. DO NOT REMOVE THE HEATER GRILLE. Clean
the body of the heater with a soft cloth.
CAUTION: Do not use gasoline, benzene, paint thinner, harsh
cleaners, etc. as they will damage the heater. NEVER USE
ALCOHOL OR SOLVENTS.
REPAIR: DO NOT OPERATE THE HEATER WITHOUT THE
GRILLE IN PLACE. DO NOT USE THE HEATER IF IT HAS
MALFUNCTIONED OR BECOME DAMAGED IN ANY WAY.
STORAGE: Keep original carton for storage of the heater.
Coil and tie the power cord to avoid damage during storage.