Comfort Zone CZ7007J Series User manual

Save These Instructions
www.comfortzoneproducts.com
Features:
• Three Heat Settings:
Low: 500 Watts
Medium: 700 Watts
High: 1,200 Watts (4,100 BTU)
• Adjustable Thermostat
• Front Mounted Control Panel
• Power Indicator Light
• Oil Permanently Filled
• Safety Tip-Over Cutoff Switch
• Durable Metal Body
• Silent Operation
• Stay Cool Handle
• 360° Swivel Wheels
• 120V AC / 60Hz / 10A
CZ7007J Series
Electric Oil Filled Radiator

2
2
INTENDED USE:
This product is intended for indoor residential and ofce use only,
not for industrial or other commercial application. Use only with
electrical wiring that is in good working order and that meets
applicable codes and ordinances. This heater must be plugged
in to a 120V AC, 15 Amp (or larger) circuit. Do not plug anything
additional into the same circuit. If you have any questions
whether your wiring is adequate, consult a qualied electrician.
Risk of re, overheating, malfunction, property damage, injury
or even death may result if not adhered to.
Use your heater only with a working smoke detector located
in the vicinity of your heater.
While using your heater, you should follow the IMPORTANT
INSTRUCTIONS listed below. As part of those instructions, we
have used the word “WARNING” to indicate the level of hazard:
WARNING indicates a hazard which, if not avoided, could result
in injury or death.
IMPORTANT INSTRUCTIONS
When using electrical appliances, basic safety precautions should always
be followed to reduce the risk of re, electric shock and injury to persons,
including the following:
• Read all the instructions before using this heater.
• This heater is hot when in use. To avoid burns, do not let bare skin
touch hot surfaces. Use provided handle when moving this heater.
Keep combustible materials, such as furniture, pillows, bedding, papers,
clothes and curtains at least 3 feet (0.9 meters) from the front of the
heater and keep them away from the sides and rear.
• Do not use heater unattended. Use of extreme caution is necessary
when any heater is used by or near children, invalids, disabled persons
or pets.
• Do not operate the heater with a damaged power cord or after the
heater malfunctions, has been dropped or damaged in any manner.
Return heater to authorized service facility for examination, electrical
or mechanical adjustment or repair.
• Do not use heater outdoors.
• Use your heater only in dry environments. This heater is not intended
for use in a bathroom, laundry area, or similar locations, or near sinks,
washing machines, swimming pools or other sources of water. Never
locate heater where it may fall into a bathtub or other water container.
Do not use in damp environments such as ooded basements.
• Do not place the heater on a small, unlevel, uneven or any surface
which might allow heater to tip or fall.
• For proper operation, heater should be placed on a smooth,
non-combustible, level surface. Do not place on rugs, carpet, vinyl
ooring or other plastic surfaces. Not for use outdoors or in wet areas.
• This heater is not designed as a primary heat source.
• Always plug heaters directly into a wall outlet/receptacle. Never use
with an extension cord or relocatable power tap (outlet/power strip).
Always unplug heater when not in use.
• Do not run power cord under carpeting. Do not cover cord with throw
rugs, runners or similar coverings. Arrange cord away from trafc area
where it will not be tripped over.
• To disconnect heater, turn controls off then remove plug from outlet.
• Do not insert or allow foreign objects to enter any ventilation or exhaust
opening as this may cause an electric shock or re or damage the heater.
• To prevent a possible re, do not block air intakes or exhaust in any
manner. Do not use on soft surfaces like a bed, where openings may
become blocked.
• A heater has hot and arcing or sparking parts inside. Do not use it in
areas where gasoline, paint or ammable liquids are used or stored.
• Use this heater only as described in this manual. Any other use not
recommended by the manufacturer may cause re, electric shock
or injury to persons or property.
READ & SAVE THESE
INSTRUCTIONS
WARNING: SHOCK HAZARD
Use your heater only in dry environments. This heater is
not intended for use in a bathroom, laundry area, or similar
locations, or near sinks, washing machines, swimming pools
or other sources of water. Never locate heater where it may fall
into a bathtub or other water receptacle. Do not use in damp
environments such as ooded basements.
WARNING: HOT SURFACES
Do not touch body of heater when in use. This heater is hot
when in use, to avoid burns, do not let bare skin touch hot
surfaces. If provided, use handles when moving this heater.
WARNING: FIRE HAZARD
Heater has hot and arcing or sparking parts inside. Do not use
near combustible materials or ammable gases or sources of
heat. DO NOT USE in areas where gasoline, paint or ammable
materials are used or stored. Keep combustible materials such
as furniture, pillows, bedding, papers, clothes and curtains at
least 3 feet (0.9 m) from the front of the heater and keep them
away from the sides and rear. To prevent a possible re, do not
block air intakes or exhaust in any manner. Do not use on soft
surfaces, like a bed, where openings may become blocked.
Do not place the heater near a bed because objects such
as pillows or blankets can fall off the bed and be ignited by
the heater. Do not insert or allow foreign objects to enter any
ventilation or exhaust opening as this may cause an electric
shock, re, or damage the heater.
WARNING: ELECTRICAL SHOCK HAZARD
Do not use with damaged cord or plug. Use with adequate
electrical system that is up to code.
CAUTION: TO PREVENT ELECTRIC SHOCK
This product has a polarized two prong plug (one blade is
wider than the other) that must be fully inserted into a matching
properly grounded outlet. This plug is designed to t a polarized
outlet only one way. If the plug does not t fully into the outlet,
reverse the plug. If the plug still does not t, contact a qualied
electrician. Do not attempt to defeat this safety feature.
Do not operate any heater with a damaged cord or plug
or after heater malfunctions, has been dropped or damaged
in any manner. Do not operate heater with a broken heating
element or ceramic cone or any visual imperfections.
Disconnect power before servicing. For repairs covered
under warranty, see warranty statement. For all other repairs
contact Comfort Zone®Customer Service by telephone
or mail for information and assistance.
PET OWNERS NOTE:
The health of birds and some small pets are extremely
sensitive to the fumes given off during the initial use of many
appliances. Although these fumes are not harmful to humans,
it is recommended that this heater not be used around birds and
small pets during its initial use until the manufacturing corrosion
coatings burn off.

3
3
WHEEL ASSEMBLY INSTRUCTIONS:
The heater is packaged with wheels unattached. You must attach
them before operating the heater.
WARNING: Operate the heater only in upright position (wheels
on the bottom, controls on the top), any other position could
create a hazardous situation.
1. Turn the heater upside down.
2. The wheel brackets should be mounded to the far ends
of the heater. Wrap “U” shaped bolt around the connector
between the heater ns.
3. Slide the angled end of the “U” shaped bolt through one
of the holes of the wheel bracket.
4. Place threaded second end of the “U” shaped bracket
through the remaining hole and tighten down wing nut.
5. Repeat the process for the second wheel bracket.
Stay Cool Handle
Control Switches
Power Indicator Light
Adjustable Thermostat
Step 1 Step 2
Step 3 Step 4
Step 5
USAGE:
HEATER OPERATION: Always operate the heater in the upright
position following all instructions and recommendations listed in
this manual.
HEATER LOCATION: Place the heater in the area of the room
that is coldest.
HEATER CONNECTION: Plug heater directly into 120V AC,
60Hz wall outlet. Be sure plug ts tightly in outlet. A loose
connection may cause overheating and damage to the plug
or heater.
NOTE: To prevent overloading a circuit, do not plug the heater
into a circuit that is servicing other electrical needs. Make
sure heater is at least 3 feet away from walls, furniture,
and other obstacles.
TURNING HEATER ON: The power indicator light will illuminate
to show the heater is plugged in and has electric power. Use the
power switches to switch to desired setting. The heater has three
heat settings: 500W, 700W and 1,200W. Use the 1,200W setting
to raise the room temperature quickly while thermostat control
is at its highest setting. (During the heaters initial use, you may
experience a slight odor or smoking. This is the result of residual
lubrication on the steel “burning off”. This is normal and will go
away after a few minutes of use.) When desired temperature is
reached, the 500W or 700W setting will be sufcient to maintain
a comfortable temperature.
CONTROL SWITCH POSITIONS:
OFF: Both switches down
LOW: Left switch up only “I” Low Heating (500W)
MED: Right switch up only “II” Medium Heating (700W)
HIGH: Both switches up “III” Maximum Heating (1,200W)
SETTING THERMOSTAT: After the unit has warmed your room
to a comfortable temperature, slowly rotate the thermostat knob
counter-clockwise until the thermostat shuts off (you will hear
a faint “click” sound). Leaving the thermostat at this setting will
automatically maintain this temperature. For a lower temperature,
rotate the knob further counter-clockwise.
TO TURN HEATER OFF: Push both control switches down.

4
4
LIMITED WARRANTY
This unit is guaranteed to the original retail purchaser
against defects in quality or workmanship for a period
of one year from the date of original purchase. If this unit
fails because of a manufacturing defect within 30 days
of purchase, return the unit, with your receipt, to the
retailer. After 30 days, but within the warranty period, if the
unit was purchased within the continental United States,
return it, freight prepaid, to World and Main for repair
or replacement. If the unit was purchased outside the
continental United States, return the unit to the place of
purchase. This warranty does not cover damage caused
by misuse, abuse, overheating or alteration. Repairs made
by anyone other than World and Main are not covered in
this warranty. World and Main will not be held liable for any
losses due to neglectful operation. All implied warranties,
including the warranties of merchantability and of tness
of purpose, if applicable, are hereby limited in duration
to the period of one year from the date of original retail
purchase. Some states do not allow limitations on how long
an implied warranty lasts, so the above limitations may not
apply to you. Incidental or consequential damages arising
from a breach of either express or implied warranties are
hereby disclaimed and excluded. Some states do not allow
the exclusion of limitation of incidental or consequential
damages, so this limitation or exclusion may not apply to you.
Upon the expiration of this warranty all such liability will
terminate. No other warranties are expressed or implied.
This warranty gives you specic legal rights, and you
may also have other rights which vary from state to state.
No informal dispute settlement mechanisms are available.
This limited warranty is given in lieu of all other warranties.
Manufactured for:
World and Main (Cranbury), LLC
324A Half Acre Rd.
Cranbury, NJ 08512 USA
800-221-6895
www.comfortzoneproducts.com
Rev. 06/07/2022
IMPORTANT SAFETY FEATURES:
The heater is equipped with an automatic overheat protection
device located inside the body of the heater. If the heater gets
too hot for any reason, the automatic overheat protection device
will turn the heater off. To reset the heater, simply turn power off
and unplug the heater for 10 minutes until it cools down and then
you may plug the heater in and restart. Be sure that the heater
is on a smooth level surface with no obstructions. The heater is
also equipped with a safety tip-over switch to turn power off to
the heater when the heater tips over. To resume heater functions
simply stand heater upright.
CLEANING, CARE AND STORAGE:
It is recommended that that the heater be cleaned at least once
per month and before storage.
1. Before cleaning, turn off and unplug the heater.
Allow it to cool completely.
2. Wipe the exterior of the unit with a soft dry cloth. DO NOT
USE WATER, WAXES, HARSH CHEMICALS OR CLEANERS,
GASOLINE, BENZENE, PAINT THINNERS, ALCOHOL
OR SOLVENTS.
STORAGE: Keep original carton for storage of the heater.
Coil and tie the power cord to avoid damage during storage.
WARNING: ALWAYS UNPLUG THE CORD BEFORE MOVING,
CLEANING OR WHEN NOT IN USE.
WARNING: IMPORTANT! DO NOT IMMERSE HEATER IN WATER!
WARNING: DO NOT ATTEMPT TO DISASSEMBLE OR TAKE THE
HEATER APART.
WARNING: DO NOT USE THE HEATER IF IT HAS
MALFUNCTIONED OR BECOMES DAMAGED IN ANY WAY.
NOTE: Do not tamper with or attempt to repair or adjust any
electrical or mechanical functions on this unit. There are no
serviceable parts inside. Tampering with or modify this product
could result serious injury, death, or re. Risk of electric shock.
REFILLING: This heater is factory sealed and never needs relling.