3. Attach the Belt Clip, as shown below if required:
Note: The handset should be used with an original power adapter only. The use of a
third-party power adapter may cause the damage to the handset. The charging status of
the handset is indicated in the top right-hand corner of the LCD screen.
2. Connect the charger cradle and charge the handset, as shown below:
4. Handset Registration
The handset in this package is not pre-registered to the base station.
Please follow the steps below:
• If the handset LCD screen prompts “Search for Base“, long press on the base
station until the first LED flashes. Then press the
OK
key to enter the main menu, and
select Settings -> Registration->Register Handset to register the handset.
• If the handset LCD screen prompts “Press base page 2s then press
OK
“, long press
on the base station till the first LED flashes. Then press
OK
soft key on the handset.
• Select the desired base (Most likely Base 1) and once search is complete, press
OK
to subscribe to the base. When prompted for a password, enter ‘0000’ or ‘1234‘
depending on the configuration of the base station.
