CommScope SCIL-B User manual

1.1 Product Description
Cable diameter range: 0-5mm, including fig.8 cable.
1.2 Kit Content
* Standard kit is listed below, alternative kits and
accessories are available.
1. 6-out multiport kit
2. Blank plugs
3. Tie wraps (8pcs)
4. Cleaning tissue
5. Foamstrip
6. Saddle seat and screw
7. Installation instruction
2 Cable Installation – Fig.8 Cable
2.1 Clean the cable for 1.5m from the cable jacket
end.
2.2 Install the cables according to the sequence
shown.
2.3 Remove the blank plugs from ports where cable
will be installed.
2.4Pull the cable through the gel block up to
1300mm.
SCIL-B 6-OUT MULTIPORT KIT
I N S T A L L A T I O NI N S T R U C T I O N
使使使使
用用用用 说说说说 明明明明 书书书书
1st 1st
2nd 2nd
3rd
3rd
TC-1362-3-IP
Rev A, Aug 2017
www.commscope.com
EM1354-001
Rev. A

2
2.5 Cable fixation position is shown below.
2.6 Wrap the cable with the foam strip at a proper
position, and secure the cable at the foam part with
tie wraps.
2.7 Install the saddle seat where the multiport kit will
be installed.
2.8 Install the tie wrap onto the saddle seat.
2.9 Insert the multiport kit into the slot shown.
2.10 Secure the multiport kit with tie wrap. Keep the
multiport kit level. Do not tilt the trigger part.
1 2 3
4
5
6

3
2.11 Remove the cable sheath at proper length, and
wrap the cable with the foam strip at the cable jacket
end. Secure the cable at the tray entrance with tie
wraps.
2.12 After closing all closure latches, screw the
multiport trigger clockwise until it stops.
3 Cable Installation – Round Cable
3.1 Clean the cable sheath with the cleaning tissue.
3.2 -3.6 Repeat 2.2 -2.6
3.7 Remove the cable jacket as shown.
3.8-3.11Repeat 2.7-2.10
3.12 Remove the loose tube up to 150mm from the
cable sheath end.
3.13 Clean the fiber bundle. Slide the transportation
tubes over the fibers up to 50mm from the cable
sheath end.

3.14 Route the transportation tubes to the tray
entrance. Secure the transportation tubes with tie
wraps.
3.15 After closing all closure latches, screw the
multiport trigger clockwise until it stops.
4. Re-entry & Additional Cable Installation
4.1 Unscrew the multiport trigger anti-clockwise first
and then open all latches to open the closure.
4.2 Repeat step 2.3.
4.3 After removing the multiport kit, store the
multiport kit at the cable port.
4.4 Repeat the steps in item 2 or 3 to install the new
cables.
© 2017 CommScope, Inc. All rights reserved.
CommScope and all trademarks identified by ® or ™ are registered trademarks or trademarks, respectively, of CommScope, Inc.
This document is for planning purposes only and is not intended to modify or supplement any specifications or warranties relating to
CommScope products or services.
This product is covered by one ore more U.S. patents or their foreign equivalents. For patents, see:
www.commscope.com/ProductPatent/ProductPatent.aspx.
To find out more about CommScope® products, visit us on the
web at www.commscope.com
For technical assistance, customer service, or to report any
missing/damaged parts, visit us at:
http://www.commscope.com/SupportCenter