CompuLab Fitlet FC-OPLN User manual

29-Aug-19
fitlet2 FC-OPLN Installation instructions
Page 1
Package content
1x FC-OPLN
FACET card
2x 3mm M3
Phillips screw
2x Retaining
washer
1x SCG tall
side panel
4x Phillips
Chassis screws
1x Deep bottom
cover
2x Brass
standoff
1x Tall side
panel
1x M3 nut
1x 8mm M3
Phillips screw

Plug the IPX connectors to the
Wifi module as follows:
Long cable to port #1
Short cable to port #2
Page 2
Remove the bottom cover by
unscrewing the 4x Phillips
chassis screws and pull out the
cooling plate gently after
removing the 3x Phillips screws.
Plug the WiFi module into the
M.2 Key-E slot and fasten with
the 3mm Phillips screw

Page 3
Install the FACET into the M.2
connectors and route the SMA
antenna cables below the
FACET
NOTE: When seating the
FACET make sure the SMA
cable is not pinched by the brass
standoff
Use the 3mm screw to fasten the
FACET to the fitlet2's SBC.
Peel the protective tape and
stick the RTC backup battery on-
top of the FACET
Connect the storage module to
the M.2 SATA slot on the FACET.

For easier installation, thread 2x
retaining washers on the 8mm
Philips screw and screw using
the hex nut from the other side.
The storage module should be
seated between the retaining
washer an the Phillips screw
Install both tall side panels.
Note: The tall WiFi side panel is
supplied separately

Peel the protective tape offthe
thermal pad and install the
bottom cover with the supplied
Phillips chassis screws.
Hold both tall side panels while
screwing the Phillips screws
Make sure the heatsink block is
aligned with the storage module.
Page 4