CompuLab fitlet2 FC-USB User manual

fitlet2 FC-PCI installation instructions
Page 1
Package
Content
2x
retaining
Washer
1x 6mm
Phillips
screw
1x FC-PCI
09-Jan-19
2x
standoff
5x 3mm M3
Phillips
screw
1x Screw
nut
2x 3mm
M2 Phillips
screw
1x
Thermal
pad

Plug the IPX antenna connectors
to the wifi module:
Long cable to port #1
Short cable to port #2
Fasten the WiFi module to the
FACET with the Phillips screw
Note:
Use the 3mm M3 Phillips screw
Plug the M.2 storage module
and screw the 6mm Phillips
screw along with the module
spacer and screw-nut which
goes below the PCB
Route the long SMA antenna
cable from the IPX connector
beneath the storage module
Plug the UFL connector to the
"Main" socket on the Cellular
modem
Attention:
The design requires to apply
insulating tape around the
modem to prevent short-circuit
with the motherboard
Plug the Cellular modem to the
mini-PCIe slot at the bottom and
fasten it with the 2x 3mm M2
Phillips screws.
Page 2

`
Seat the FACET into the M.2
sockets.
Keep it in an angle as the next
step explains the SMA antenna
cable routing.
Pay attention to the way the
antenna cables are routed below
the seated FACET.
Note:
In case a cellular modem was
not installed, and the standoff
haven't been removed,Pay
attentionto the longer cable, it
should be routed around the
standoff, make sure the FACET
doesn't pinch it when pushed
down.
Note:
In case a cellular modem has
been installed, the standoff
adjacent to the USB connector
may collide with the modem -
Remove it
Page 3
Assemble the RP-SMA
connector with the Cellular
antenna side panel
SIM slot located at the top of the
FACET.
Before pushing down the FACET
for final assembly, the cables
should be free and loose.

Stick the RTC backup battery in
its place
Page 4
Assemble the 2x 3mm Phillips
screws at the stand off locations.
If the standoff has been removed
as per step 5, do not screw at
the M.2 connector location.
Apply the thermal pad on-top of
the M.2 SSD
Note
Before placing the bottom cover,
make sure the U-shaped Boss is
on the side of the M.2
connectors
Screw the 4x Phillips enclosure
screw half way, enough to hold
the bottom cover in-place but not
too tight
Complete by tightening the
Phillips enclosure screws all the
way down, while holding the side
panels
Bring both side panels in place,
and hold them