Conair GS23 User manual

Quick Start Guide for Assembly & Use of Your Fabric Steamer
fabric steamer
DUAL HEAT
™
with
STEAMING TIPS & HINTS
• Before using your steamer, please
carefully read the instruction booklet
provided.
• During use, always hold the T-nozzle ½"
(13mm) from the fabric you are steaming.
CAUTION/STOP
!Always test fabric to be steamed for
color fastness in an inconspicuous spot.
If you see a color change or color
transferring to the T-nozzle from your
fabric, STOP steaming immediately!
This item must be dry cleaned only!
!
When steaming drapes or curtains,
rst wash and dry according to care
instructions and fabric type, then rehang
and steam.
!
Do not steam clothes while wearing
them.
!
Do not use hot water to ll the tank.
Do not overll.
!
Do not place garment or item on wire
hanger. Use plastic hanger or hang from
shower rod for easy steaming.
Parts in Box:
Steamer Brush CreaserWater Tank Soft Cushion
Brush
Effective on all types
of fabrics, linens & drapes
gs23x_13pa143391_quickstart_guide_comp.indd 1 5/22/13 3:48 PM

A
FD
For information on any Conair product call 1-800-3-CONAIR or visit us on the web at www.conair.com
fabric steamer
DUAL HEAT
™
with
B
OPERATING INSTRUCTIONS
1. Plug the unit into the electrical outlet.
2. The power light (A) will light up (red). Allow
one or two minutes for the unit to warm up.
The appliance is ready to use when the
ready light goes on (green) (B).
3. Holding the steam jets away from you and anyone else
in the room, engage the trigger (C). Steam should now be
released from the steam jets. To have continuous steam,
just move switch down (C) so you will have continuous
steam without having to hold the trigger. Always have
steam facing away from you or anyone in the room.
4. When first using the device, test on an old cloth, as there
may be sediment left from the manufacturing process or
transportation.
5. On the back of the steamer there is a sliding switch for high
and low settings (D). High is for heavier and badly wrinkled
fabric and provides faster, hotter, less visible steam. Low setting
should be used for delicate fabrics like silk, in combination with
soft cushion brush attachment.
6. To stop the flow of steam, release the trigger (C) or move the
switch upward if on constant steam.
7. Unplug the device when it is not in use.
FILLING INSTRUCTIONS
1. Make sure unit is unplugged.
2. Place the unit on its back on a flat and stable surface.
3. While holding the water reservoir with one hand, move the
release switch up toward the steam head nozzle.
4. Pull the reservoir out, away from the body.
5. Turn the reservoir over, revealing the rubber inlet cover.
6. Open the inlet cover and fill the reservoir with everyday tap
water (filtered water may reduce hard water problems).
7. Close the inlet cover and return the reservoir to its place,
making sure that it is secure.
ADDING ATTACHMENTS
1. Simply take attachment out of box and
place top portion of attachment
to top of steamer (E) and snap on lower
opening below steamer nozzle (F).
E
C
gs23x_13pa143391_quickstart_guide_comp.indd 2 5/22/13 3:49 PM