Confer Plastics 635-52X User manual

*Model 635-52X is a
straight up-and-down
ladder and should be
installed 3” to 6” from
the pool wall.
Note: 10 Lbs of
sand required
(See Step 2)
SAND
MODEL #635-52X
ALL PLASTIC INPOOL LADDER
Adjusts to fit pools 46” to 56”
Ladder must be attached to deck
WEIGHT LIMIT 250 LBS.
ASSEMBLY, INSTALLATION AND USE MANUAL
Assembly video available online: www.conferplastics.com
To reduce the risk of drowning, entrapment, falls, paralysis, electrocution, or
other serious injury or death:
Dealer/Installer: Give manual to homeowner.
Installer: Read "Safe Installation" on page # 2 and all instructions before beginning. For proper assembly and
installation, instructions must be followed completely.
Homeowner: Read "Safe Use" on back cover before using. Save these instructions.
Installation must comply with local codes and may require permits.
S
Proudly Made in U.S.A. by

Step 2.
Pour 5 lbs of sand
into each leg. Fill
remainder with water.
Parts List Tools Needed for Assembly
2 - Handrails * Sand - 10 lbs
1 - Ladder Section * Cordless Drill
1 - Platform * 1/8” Drill Bit
* Phillips Screwdriver
Hardware Pack * Tape Measure
14 - #10 x 1-1/4” Screws * Liquid Soap or Lubricant
1 - Threaded Cap
2 - Mounting Blocks
2 - Adjustable Tubes
Ladder
Handrails
Mounting
Blocks
Adjustable
Tubes
Platform
Step 1.
Install threaded cap
over bottom drain hole.
Model #635-52X All Plastic Inpool Ladder
Ladder must be attached to deck
If missing parts call - Toll free U.S./Canada - 800-635-3213 or www.conferladders.com
Safe Installation
To reduce the risk of electrocution, drowning, entrapment, falls, or other
serious injury or death:
Check building codes/permitting. Consult your local Building Department before installation of your pool and
equipment. Pool/equipment installation must comply with the codes of the authority having jurisdiction and
may require permits (e.g., building, plumbing, electrical, zoning, etc.). Be sure that barriers (fences, gates, etc.)
restricting pool access meet local codes.
Use for intended purpose only
• Use only as a swimming pool ladder.
• This ladder is designed and manufactured for a specic pool wall height and/or deck of the pool - check
product specication and the height of your pool.
Check that you have all required parts. Check the contents of the carton with the Parts List for this ladder. All
parts and hardware are required. If any parts are missing, DO NOT attempt to assemble or install the ladder.
Instead, call Toll Free U.S. - 800-635-3213 or visit our web site at www.conferladders.com for assistance.
Select an appropriate location - The ladder must be located on a level, solid base and in a location that will be in
full view of competent adult supervision when in use.
Follow all instructions
• For stable, correct assembly and installation, all instructions must be followed completely and in the
sequence shown.
• Follow the manufacturer’s recommendations for the safe use of all hand tools and equipment used during
installation.
Cordless drill only - no corded drills near pool. Use a cordless drill for assembly and installation. To reduce the
risk of electrocution, NEVER use a corded drill in or around a pool.
Lift safely. When lifting awkward or heavy loads, have another person help you.
Double check after installation
• Before using the product, after assembly and installation, go over the instructions and procedures again to
make sure nothing has been overlooked.
• Make sure that safety labels are installed and legible.
2

Step 4.
Insert tabs on platform
into handrail. Repeat
for 2nd handrail.
Step 5.
Insert wedge into handrail just below the
platfom tab, using rubber mallet tap into
place. repeat to install remaining three [3]
wedges into handrails.
Step 7.
Coat the adjustable tubes with a little
liquid soap. Slide the mounting block over
the tube and slide all the way down until
resting on the nubs.
Step 3. Using a knife care-
fully remove all
four [4] wedges.
Step 8.
Push the adjustable tubes
up into the handrails.
Step 6.
Slide the hand-
rails onto the
legs.
DO NOT
secure with
screws at
this stage.
Step 9.
Place the ladder into the pool and position mounting
blocks on deck. Slide the adjustable tubes up or down
as needed until mounting blocks are sitting flush on
the deck. Ladder MUST rest on pool bottom. If not,
EB100 riser(s) are required. (See page 3 to order)
Step 10.
Drill four pilot holes (1/8”) through holes in
each block into wood surface. Fasten blocks
to deck using the four #10 x 1-1/4” screws per
mounting block. Drill three holes through each
side of each handrail at the pre-marked
locations. Fasten using three #10 x 1-1/4” screws.
Slide down into position
once mounting blocks
have been fastened.
3
WARNING! Using a corded
drill near pool may result in
electrocution.

SKIM-IT (SKIMS OFF
DEBRIS)
- Cut cleaning time 75%
with skimmer extension that
guides debris directly into your
skimmer. Fits most in-ground
and above-ground pool
skimmers. Corrosion-resistant
plastic Skim-It installs in
seconds without tools.
4
CP-635-52X REV. 12/18/18
97 Witmer Road
North Tonawanda, New York 14120-2421
Toll Free U.S. 800-635-3213
FAX [phone]
www.conferladders.com
WINTERIZING: WINTERIZING: Unfasten the ladder from the adjustable tubes and remove from water.
Lay the ladder on its side to drain. It will take several minutes for the water to drain out of the ladder rails and
treads. A small amount of water left in the ladder will not cause any damage. To reinstall, see Step #9.
CONFER PLASTICS INC. FIVE YEAR WARRANTY
Confer Plastics Inc. warrants their swimming pool ladders and steps to be free from defects
in workmanship for five years from date of purchase.
DO NOT RETURN DEFECTIVE PART TO DEALER
E-MAIL CONFER PLASTICS AT: [email protected]
A PICTURE [S] OF DEFECTIVE PART, A BRIEF DESCRIPTION OF PROBLEM,
PROOF OF PURCHASE AND YOUR CONTACT INFORMATION.
INFORMATION MAY ALSO BE FAXED TO CONFER PLASTICS AT: 716-694-3102
OR MAILED TO THE ADDRESS BELOW. UPON REVIEW OF THE INFORMATION YOU
WILL BE NOTIFIED IF PART IS COVERED UNDER THE WARRANTY AND
THE SHIPPING/HANDLING CHARGES.
This warranty gives you specific legal rights, and you may also have other rights which may vary from state to state.
Confer Plastics Inc., 97 Witmer Road, North Tonawanda, N.Y. 14120-2421
Safe Use
To reduce the risk of drowning, entrapment, falls, paralysis, or other
serious injury or death:
Use ladder properly.
• No diving or jumping from ladder - shallow water; risk of paralysis or death.
• FOR ENTRY/EXIT OF POOL, FACE THE LADDER AT ALL TIMES.
• ONE PERSON ON THE LADDER/STAIR AT A TIME.
• To reduce the risk of entrapment or drowning, DO NOT swim through, behind or around ladder.
• Illuminate the ladder when using the pool at night.
Weight limit - 250 lbs maximum. Exceeding maximum weight may cause the ladder to fail.
Secure ladder when not in use. When pool is not in use, make sure gate is closed and locked.
Watch children at all times when they are in or around water to help prevent drowning.
BE SURE AND SAFE. The manufacturer IS NOT responsible for improper assembly Installation and use.
ADDITIONAL ACCESSORIES MAY BE PURCHASED
Order online at www.conferladders.com
Printed in USA
S
MADE IN THE USA
Used to raise ladder
when deck is built
higher than pool.
Maximum 2 risers.
Fill with sand and
water, rest ladder
on top.
Straps included.
EB 100-3” RISER