Connects2 Vision CAM-34 User manual

www.c2vision-eu.comwww.c2vision-eu.com
Image Sensor: 1/3” HD CCD
TV Lines: 480
Resolution: 800 x 480
Minimum Illumination: 0 Lux (LED’s on)
TV System: NTSC
Waterproof Rating: IP68
Infa-red LED’s: Yes
User Manual
Read the manual prior to installation. Technical knowledge is necessary for installation. Please ensure you
use the correct tools to avoid damage to the vehicle or product.
Connects2 can not be held responsible for the installation of this product.
Universal Camera
For Trucks, Vans & Motorhomes
PRODUCT SPECIFICATIONS:
DISCLAIMER
CAM-34
Viewing Angle: 170 (H) 120 (V)
Video Output: 1.0V p-p 75ohm
Parking Lines: Yes (Removable)
Image Adjustment: Yes (Mirror/Normal)
Operating Voltage: 12 - 32V DC
Standby Current: 100mA @ 13.8V
Operating Temp: -10 °C to 65 °C
• Universal camera for installation into many
types of vehicle
• High-quality, durable construction for use
in harsh weather conditions
• Mounting bracket with pivot for reliable
installation and adjustable angle
• Removable parking guidelines to provide
support during manoeuvres
Technical Support
Connects2 want to provide a fast and suitable resolution should you encounter any technical
issues. With this in mind, when contacting Connects2, try to provide as much Information as
possible. This will speed up the process and help us to help you.
Please use our dedicated online technical support centre: support.connects2.com

2
Connects2Vision
www.c2vision-eu.com
CONTENTS
• Reversing camera with 30cm cable (including blue/white wiring loops) to
female 4pin camera connector
• Instructions
Note: CAM-RCA1 extension lead is required for installation
INSTALLATION
1. Connect the black wire of the extension cable to a suitable ground and the
red wire of the extension cable to a switched +12V supply.
Note: If the camera is to be used in the rear of the vehicle, the red wire should
be connected to the reversing light circuit or an interface which provides a
reverse signal.
2. Connect the red and white RCA connectors of the extension cable to a
suitable display
3. Using the supplied mounting bracket, mount the camera in the required
position
Note: Adjustment of the camera may be required to ensure that the correct
angle of the image is achieved and that the distance markers on the parking
lines correspond to that of the object in view.
4. Connect the female 4pin connector from the camera cable to the male
4pin connector of the extension cable and test for correct operation.
PRIOR TO INSTALLATION
Choosing Mirror or Normal View
To swap the image from the camera from mirror to normal view, disconnect the
shorting link from the small white looped wire located on the camera cable.
Turning Parking Guidelines On or Off
To remove the parking line feature, disconnect the shorting link from the small
blue looped wire located on the camera cable.
Note: Select a suitable location for the camera and ensure that the area is free from all cables, fuel
and oil. Whenever possible, avoid locations that are subject to road dirt & water spray. Ensure that the
vehicle ignition is turned off during the installation