2
Connects2Vision
www.c2vision-eu.com
CONTENTS
• Camera with Male 7pin camera connector
• 10m Female 7pin to Male 7pin extension cable
• 7pin Male aviation connector to 2x Female 4pin connectors (1x Yellow, 1x Black)
• 2x 4pin Male aviation connectors to 2x Female RCA’s (1x Yellow, 1x Black)
• 2x DC power cables with Male DC connector to bare wires
• 2x Male to Male RCA adapters
• 3M camera shaped foam pad
• Instructions
INSTALLATION
1. Remove the third brake light from the vehicle and unplug the connection
cable.
2. Ret the CAM-FD13 (if needed, with the use of the 3M foam pad) to the
vehicle, taking care not to trap any cables.
3. Connect the 7pin of the extension cable to the camera and thread through
the vehicle
4. Attach the Female 7pin connector from the extension to the 7pin to dual
4pin adapter.
5. Take the 2x 4pin connections and attach both the 4pin connectors found on
the RCA/DC split wire.
6. Use both the DC power cables to plug into the black connector and
proceed to wire the red to a source of 12V and black to a source of ground.
7. Use the RCA adpater to plug into the yellow RCA on the harness, and
proceed to plug this into the aftermarket accessory’s video input(s).
8. Test the camera connection by turning on the ignition. The rear camera feed
should now be visible on screen. Put the vehicle into reverse and the reverse
camera feed will automatically populate on screen.
If camera feed is unresponsive, please uninstall the wiring and reinstall carefully
in accordance with the above steps.
9. The camera will be default with parking guidelines. To remove this, simply cut
the black loop wire found on the camera’s connector.
For further help and support, please contact us directly at
support.connects2.com/tickets/technical
and ll out a support ticket with the full details of your issue.
Subscribe to our YouTube Channel for installation
guides and tips... www.youtube.com/connects2
