Connex FALCON 2 User manual

INSTRUCTION MANUAL
Please read and retain these instructions for future reference.
CP102
FALCON 2
PC Projector With Wi-Fi Connectivity
TM

• 3500 Lumens
• Up to 1080P
• Wi-Fi Screen Share / Multi-Screen
• USB / HDMI / VGA / AV
• Built-in Speakers
• Universal Compatibility
2
HIGHLIGHTS
• Projection System : 4.0 inch LCD TFT display
• Projector Resolution : 1280 x 720, support 720P / 1080P
• Brightness : 3500 Lumens
• Image Flip : 360° ip
• Projection : Forward / Back Projection / Drop
• Focusing Method : Manual
• Contrast Ratio : 2,500:1
• Aspect Ratio : 16:9 and 4:3
• Lamps Type : LED 70 W , 30 000 hours life
• Projection Size : 40 - 180 inch
• Keystone : 45 degree physical corrections
• Noise : <45 dB
• Working Voltage : 110 - 240 V / 50 - 60 Hz
• Input Ports : USB X 2 / HDMI / AV / VGA / 3.5 mm
• Machine size : 25 x 17 x 8 cm
PACKAGE CONTENTS
SPECIFICATIONS
• Connex Falcon 2 Projector
• Power Supply
• HDMI Cable
• Remote Control
• User Manual

3
IDENTIFYING PARTS
THE FRONT COVER MUST SLIDE OPEN TO TURN ON / OFF THE PROJECTOR

4

5
OPERATING INSTRUCTIONS
GETTING STARTED
Connect the Power Cord to the Power Input slot located on the back of the
Projector, and then plug the other end of the cord into a plug outlet. The LED
Indicator will light up red when power is connected to projector.
SWITCHING ON / OFF
To switch on the Falcon 2 Projector, press the power button on the Remote or slide
open the front cover on the projector. The Projector will play a boot sequence on
its screen. To switch off the Falcon 2, press the power button on the remote or
slide close the front cover on the projector.
STANDALONE STREAMING
The Projector can be used as a standalone device to share content from a variety
of devices with a wired connection or from a USB ash drive.
KEYSTONE CORRECTION / LENS FOCUS
Use the Keystone Correction Turn Dial to adjust the angle of the Projector. Use the
Lens Focus Turn Dial to adjust image focus to make picture clear.
MULTIMEDIA CONNECTION
To connect to the USB drive select the source “Multimedia” or press the USB
Button on the remote. Then navigate to the le type that you want (movie, photo,
music or text) using the directional keys. Select the le you would like
to view by pressing the Play / Pause button or the OK button on the remote
or the OK button on the projector.
AV VIDEO CONNECTION
Connect the 3-in-1 Cable (included) to the Video Input on the back of the
projector. Navigate to the AV Media Source and press either the OK Button on the
Remote Control or the OK Button on the Projector.
HDMI CONNECTION
Connect an HDMI cable to the HDMI Input on the back of the projector. Navigate
to the HDMI media source and press either the OK Button on the Remote Control
or the OK Button on the Projector.
Note: The projector is now in standby mode.

6
VGA CONNECTION
Connect a VGA cable to the VGA Input on the back of the Projector. Navigate to
the VGA media source and press either the OK Button on the Remote Control or
the OK Button on the Projector.
AUDIO CONNECTION
Connect a 3.5 mm jack cable to the 3.5 Output on the back of the projector.
WIRELESS PROJECTION: iOS DEVICES
Select the Wireless projection option via the source button on the projector’s
control panel. Press the ”OK” key on the remote control and then switch the
system to iOS.
Open the iOS device, go to ”WIFI” from settings to search for the name of the
projector to be connected, then open the mirror function of the iOS device. Select
the projector name and input the password to connect successfully.

WIRELESS PROJECTION: ANDROID DEVICES
Select the Wireless projection option via the source button on the projector’s
control panel or remote control. Press the ”OK” key on the remote control and then
switch the system to Android.
NOTE! Support iOS6 or above.
Open your Android device, go to ”Device connectivity” from settings and select
”Wireless projection” and search for projector name ”Connex Falcon 2”. Select the
projector name to connect.
7

WIRED PROJECTION: iOS DEVICES
Select the Wireless projection option via the source button on the projector’s
control panel or remote control. Press the ”Ok” key on the remote control and then
switch system to iOS.
NOTE: Support Android 5.0 or above.
Connect to the USB interface through the Apple data cable. For the rst time (after
connecting to the projector, it will connect automatically), a dialog box will pop up
to ask ”Trust the device?”, Click ”Trust” and wait for 3 - 5 seconds, the content of the
iPhone or iPad will be projected to the projector screen.
8

9
WIRED PROJECTION: ANDROID DEVICES
Select the Wireless projection option via the source button on the projector’s
control panel or remote control. Press the ”Ok” key on the remote control and then
switch system to Android.
NOTE: Some iOS devices will pop up the ”This accessory may not be
supported” window, please feel free to use it because this the normal
notication. Please wait patiently while the wired connection program
updates if the mobile phone system version is outdated.
Connect a data cable to the USB2 interface. Open the ”USB tethering” in the
mobile phone’s ”Settings” interface. Wait for 3-5 seconds to connect successfully.

10
NOTE: The USB debugging mode must be turned on when using this function.
Please wait patiently for the wired connection program to update.
Supports Android 5.0 or above.
• Never use your projector near water or in areas where it can come into contact
with water. Never handle the projector if it was dropped in water or any other
liquid. If the product comes into contact with water while switched off, but still
plugged in it is a safety hazard.
• Always make sure your hands are dry before touching the plug or power
connections.
• Do not operate the product with a damaged cord or plug, or after it
malfunctions, has been dropped, or damaged in any manner.
• The Falcon 2 is intended for personal use only. Commercial use invalidates the
warranty and the supplier cannot be held responsible for injury or damage
caused when using the device for any other purpose than that which it was
intended for.
• This projector is not intended for use by children, or persons with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge,
unless they have been given supervision or instruction concerning use of the
device by a person responsible for their safety. Extreme caution must
be exercised.
• Children should be supervised to ensure that they do not play with the Projector.
Packaging must never be left within reach of children, as it is potentially
dangerous.
• Do not cover the vents of the projector as this may lead to excessive heating of
the Falcon 2 components.
• Always leave a minimum distance of 10 cm around the unit to ensure sufcient
ventilation.

11
• Before Cleaning: Ensure that your Falcon 2 projector is not plugged into any
device or power source before cleaning or maintaining it.
• Cleaning: Wipe down the surface of your Falcon 2 using a soft,
slightly damp cloth.
To clean the lens, use a dry microber cloth and gently wipe until it is clean.
• Do not use any harsh or abrasive cleaning chemicals or materials on your
Falcon 2 as doing so may damage or scratch the surface nish or the lens.
• Do not expose your Falcon 2 to direct sunlight or high temperatures for
extended periods of time.
• Do not store in temperatures over 60 ° C.
IMPORTANT INFORMATION FOR CORRECT DISPOSAL OF THE PRODUCT IN
ACCORDANCE WITH THE EUROPEAN DIRECTIVE ON WASTE ELECTRICAL
AND ELECTRONIC EQUIPMENT.
• At the end of its working life, the product must not be disposed of as urban
waste. It must be taken to a special local authority differentiated waste
collection center or to a dealer providing this service. Disposing of a household
appliance separately avoids possible negative consequences for the environment
and health deriving from inappropriate disposal and enables the constituent
materials to be recovered to obtain signicant savings in energy and
resources. As a reminder of the need to dispose of household appliances
separately, the product is marked with a crossed-out wheeled dustbin.
• Never dispose of used electronics with ordinary solid waste since they contain
toxic substances.
• Always dispose of used electronics in accordance with the prevailing community
regulations that apply to the disposal of electronics. If there are no regulations
concerning electronics disposal, please dispose of the device in a waste bin for
electronic devices.
CLEANING & CARE INSTRUCTIONS
CLEANING & CARE INSTRUCTIONS
ENVIRONMENTALLY FRIENDLY DISPOSAL

12
All product and company names are trademarks™ or registered® trademarks
of their respective holders. Use of them does not imply any afliation with or
endorsement by them.
The terms HDMI and HDMI High-Denition Multimedia Interface, and the HDMI
logo are trademarks or registered trademarks of HDMI Licensing LLC in the United
States and other countries.
This Falcon 2 Series Projector comes with a standard 12-month limited warranty
against manufacturing defects and faults. Should your product be unboxed with
any faulty parts, poor nishing or visible damage, or fail to perform due to a
manufacturing defect or poor workmanship, please return it with your proof of
purchase (till slip or invoice) to the store of purchase for an exchange,
or repair, depending on the store’s returns policy.
This warranty commences from the date of purchase.
Kindly retain your proof of purchase as well as the packaging for your warranty
period.
NOTE:
The warranty does not apply to a product that:
a.) Has failed due to excessive wear and tear beyond what is
considered to be reasonable.
b.) Has been misused or neglected.
c.) Has been damaged accidentally or by Force Majeure including re
and ooding.
d.) Has been used or operated contrary to operating or maintenance
instructions outlined in this manual.
The Store of Purchase / Seller cannot accept any returned products that have not
been returned in accordance to this warranty or which does not follow their own
Returns Policy. Please refer to the Store of Purchase / Sellers Returns Policy
for details.
Should you require any further assistance or have any questions on your warranty,
please contact the store of purchase.
DISCLAIMER
WARRANTY