Contours Graze ZW002 User manual

2-STAGE WALKER
ContoursBaby.com
Model # ZW002
W039-R1 01/2023
Scan for instructional video

2ContoursBaby.com
Read all instructions BEFORE assembly and USE of the walker. Failure to follow these warnings and instructions could result in serious injury
or death. For your child’s safety, read the labels and the instructions before using product. Keep instructions for future use.
IMPORTANT SAFETY INFORMATION:
How to Keep Your Child Safe While Using this Product
• NEVER leave child unattended. Always keep child in view while IN WALKER.
• CHOKING HAZARD-Small parts. ADULT ASSEMBLY REQUIRED.
This package contains small parts which, before assembly, present a choking hazard to children under the age of three. Care should be
taken during unpacking and assembly to ensure that all small parts and plastic bags are accounted for and kept out of the reach of
children. All fasteners should be fully tightened.
STAIR HAZARD
• Avoid serious injury or death. Block stairs / steps securely before using this walker.
• Use only on flat surfaces free of objects that could cause this walker to tip over. Never use near stairs, steps, thresholds, hills, roadways, or pools.
• To avoid burns, keep child away from hot liquids, stoves, radiators, space heaters, fireplaces, etc.
• Discontinue using this walker should it become damaged or broken.
• Never carry this walker with child in it. Never adjust seat while child is in product.
• DO NOT lift or carry by tray.
• DO NOT use this walker until baby can sit up unassisted.
• To reduce the chance of child slipping out of seat, check that both feet of child touch the floor.
• Discontinue use of activity walker (seated stage) when your child can stand unaided, walk unassisted or lift the walker off of the floor.
• To maintain stopping performance, clean friction strips regularly with damp cloth.
Only use this activity walker (seated stage) if your child MEETS ALL of the requirements below:
1. Can support body weight with legs
2. Weight is between 15 and 26 pounds.
3. Height is less than 32 inches and child is not able to stand flat footed while in the walker.
CARE & MAINTENANCE
1. Plastic Parts: Wipe clean with mild soap and a damp cloth. Air dry.
2. Seat Pad: Machine wash in cold water in gentle cycle. Air or hang dry. DO NOT use harsh detergents or bleach. DO NOT dry clean.
3. Removable Insert Tray is dishwasher safe, top rack only.
NOTE: To maintain stopping performance, clean friction strips regularly with damp cloth.
lWARNING

ContoursBaby.com 3
PARTS LIST
FRONT CASTERS (2)SEAT PAD
TRAY & LEGS SIDE BASE LEGS (2) FRONT MOUNT
REAR WHEELS (2) AXLES (2)
SCREWS (8)
REMOVABLE INSERT TRAY

4ContoursBaby.com
Tabs
Tabs
Grooves
2-1 2-2
x4
1-1 1-2
ASSEMBLE WALKER FRAME
One-time assembly.
1-3
ATTACH SEAT PAD
2-3
Test: Push down hard on
seating area of seat pad to
make sure seat is securely
in place.
CAUTION: Do not use
walker if all tabs are
not secured properly,
otherwise child may
fall through walker.
Flip base over to expose underside.
Note: Plastic tab may need to be pushed to the side to expose axle hole.
Front leg button should be visible.
x8
BOTTOM VIEW
x4
x4

ContoursBaby.com 5
ATTACH REAR WHEELS
3-1 Tab
Flip base over to expose underside.
Note: Plastic tab may need to be pushed to the side to expose axle hole.
4-1
ATTACH FRONT CASTERS
Test: Pull up on caster to make sure it is locked in place.
Top Lip of Caster
Threads
x2 73
x2
lCAUTION

6ContoursBaby.com
ATTACH REMOVABLE INSERT TRAY
5-1
6-1
CONVERT TO WALK-BEHIND WALKER
7-1
ADJUST SEAT PAD HEIGHT
To Remove: Lift up on tray tabs.
lWARNING
DO NOT disassemble or
adjust height while baby is
sitting in or near product.
Always make sure seat pad
is adjusted to the correct
height position before
placing child in product.
Note: As your child begins to grow, adjust height of walker via the seat pad so
that their feet touch the ground when seated. To determine correct height after
assembly, place child in walker and make sure both feet touch the ground.
CAUTION: Child should not be in the walker during adjustment.
Note: To ensure proper operation, you will need to periodically adjust the height
adjustment strap to accommodate your child’s increased height. For smaller
babies, seat pad should be extended to its lowest position. To adjust seat height,
push button in on height adjustment strap to release webbing.
As baby grows, raise seat by tightening the height adjustment strap. This helps
to prevent the child from placing their feet flat on ground and prevents your child
from climbing out.

ContoursBaby.com 7
TO FOLD WALKER
8-1 8-2
8-58-48-3
Push In Front Leg Button

8ContoursBaby.com
Contours® - United States
1100 W Monroe St
Chicago, IL 60607
1-888-226-4469
[e-mail]