Convaid Trekker User manual

Trekker™
Removing Seating Module

Removing Seating Module
Instructions
1. Adjust back to upright position. Seat
module MUST be parallel to the floor.
2. Push Safety Lock release lever.
Safety Lock
3. Lift seating module release bar
Release Bar

Removing Seating Module
Instructions
5. Pull seating module forward to disengage
the Docking Hooks from docking platform.
6. Lift seating module and remove
from base.
Docking Hooks

Trekker™
Installing Seating Module in Reverse
Configuration

Installing Seating Module in Reverse
Configuration Instructions
1. Before reversing seating base, pull tilt-
stopper up. This will ensure proper docking
of the seating system.
2. Reverse base and align seat docking
hooks on the back tube of the docking
platform.
Docking Hooks
Docking Hooks

Installing Seating Module in Reverse
Configuration Instructions
3. Pull on the safety lock release lever and
engage to seat base lock bar.
Safety Lock
Lever

When installing seating module in reverse
configuration on a Trekker size 14 with transit
brackets.
Install seating module at a 45° degree level,
to avoid anchor brackets from interfering with
frame bottom bar.
Tip
Trekker 14 with Transit
Brackets

Trekker™
Installing Seating Module in Forward
Configuration

Installing Seating Module in Forward
Configuration
1. Before installing base in forward
configuration, pull tilt-stopper down. This will
ensure proper docking of the seating system.
Tilt Lever DOWN
2. Face seating module in forward
configuration and align seat docking
hooks on the back tube of the docking
platform.
Docking Hooks

Installing Seating Module in Forward
Configuration
3. Push safety lock release lever and engage to
seat base lock bar.
Safety Lock Lever