ConvaQuip 724A User manual

ConvaQuip Ind., Inc.
Manual
for
Model 724A
Bedside Commode
Cleaning Instructions:
* For infection control, clean all parts with one part bleach and 9
parts water. Rinse and allow to air dry or wipe with a clean, dry
cloth.
* Clean rubber tips with alcohol to remove oil, grime and dirt
* Pail may be steam cleaned or use Beaucoup disinfectant
(made by EcoLab) or equivalent.
Model 724A:
CAUTION: Make sure toilet seat ring is firmly in the down posion and resng against the top
of the frame in order to prevent pinching skin. Once seat ring is in place, slowly lower yourself
into a sing posion. Keep hands and fingers on the armrests while lowering into posion.
CAUTION: Posion the bedside commode against a wall prior to use. The tubular back needs to
be touching the wall when entering or exing the bedside commode to prevent pping.
Capacity 750 lbs.

Assembly
Model 724A
Bedside Commode
ConvaQuip Ind., Inc.
Bottom Half Top Half
Set top half on bottom half.
Slide down over the tubing until the
tubing will rest on all four snap buttons.
Close up of tubing resting on snap button.
Press in the snap button on each leg and barley
push down the tubing, just enough for the
button to disappear. Now slowly and in small
increments move from leg to leg pushing the
tubing down.
If you push too far on any leg, it will bind up
and you will have to even them out again by
pulling it up and starting over. Once all four
tubes have bottomed out, the button will
reappear and snap into place. When all buttons
are protruding through the button hole, the
commode is ready to use.