Cornelius VANGUARD 245 User manual

1
IMI CORNELIUS INC. 1996 August 13, 1996
TD243
IMI CORNELIUS INC.
One cornelius Place
Anoka, MN 55303-6234
Telephone [phone]
Facsimile [phone]
INSTALLATION MANUAL
FOR
VANGUARD 245 CHILLER
The Vanguard 245 Chiller is for chilling incoming water before it enters the beverage system. It is for use in high
ambient water conditions and high volume beverage locations where additional cooling is required. Pre-chilling
of the water improves the output of the beverage dispensing units.
The unit can sit on the floor or be mounted on the wall with the brackets as shown below. When mounting the
unit on the wall make sure air intake side is not facing the wall. The air exits the top. Make sure nothing is cov-
ering the top to ensure proper operation.
The separate 3-way water manifold should be attached to the 3 water inlets. Inlets 1 and 2 are for water to the
two carbonators on the back room panel or B-I-B stand, which has shut off valves on the panel. Inlet number 3
with a shut off valve and outlet number 3 is a separate circuit to supply chilled water to the ice machine (see
diagram).
The Vanguard 245 Chiller uses mechanical refrigeration in a water bath to chill the coils that the water passes
through.
Specifications
Width 24.5 (62 CM)
Height 31 (79 CM)
Depth 30 (76 CM)
Electrical 220V/50Hz 9.0 Amps or 115V/60Hz 15.0 Amp 20 Amp Circuit
Compressor 3/4 H.P. Refrigerant 404a
Ice Bank 62 lbs. (28 Kgs.)
Shipping Weight 180 lbs. (82 Kgs.)
Operating Weight 245 lbs. ( Kgs.)
23 23
4
11 1/219
23
1. Two-inch angle iron, 3 pieces per bracket.
2. Drill 1/2holes, weld all pieces

2
3. Mount brackets on wall and tie together with shelf or bars.
WATER
INLET
VANGUARD 245
CHILLER
10 FEET OF INLET HOSE
3 WAY WATER MANIFOLD
WATER
OUTLET
TO BEVERAGE PANEL
OR BIB STAND
23
WATER SHUTOFF VALVE
TO ICE MACHINE
1231
231
TOP VIEW
30
24.5
4. Mount three black brackets to the wall.
5. Install unit on black angle bracket.
6. Install 3 way water manifold to inlet side of the unit (see diagram).