Cornell CFN- E160TRC User manual

1
CFN-
E1 6 0TRC
1 6 " Stand Fan
With Remote and Timer

2
PLEASE READ AND SAVE THESE INSTRUCTION
PARTS NAME
Description
1. Front guard
2. Retaining nut
3. Fan blade
4. Locking nut
5. Rear guard
6. Motor shaft
7. Motor housing
8. Neck
9. Control box
10. Screw
11. Internal pole
12. Height adjustment ring
13. Outer pole
14. Base
15. Screw
16. Remote controller
COLUMN ASSEMBLY INSTRUCTIONS
Take the base and column parts from the packing box and loose the plastic nut. Fix the
column on the base plate using the plastic nut. Unscrew the height adjust-ing knob.
Mount the column ornament, and move to the desired height. Then screw the height
adjusting knob to tighten the extension pole.
16
OPERATING INSTRUCTIONS
RATED VOLTED
220-240V
INPUT POWER
50/ 60Hz 60W
FREQUENCY

3
FAN BODY ASSEMBLY INSTRUCTIONS
1. Unscrew the spinner clockwise and the nutcounter-clockwisetoremovebothof
them.
2. Set the rear guard in the proper position with handle up.
3. Screw on plastic nut tightly to attach rear guard.
4. Discard plastic sleeve on motor shaft.
5. Install the blade onto the motor shaft until it reaches the retaining pin.
6. Screw spinner onto motor shaft counter clockwise to blade.
7. Press the rim of the rear guard onto the front guard until the rear guard is properly
fitted.
8. Secure both guards firmly by tightening the fan guard then close easy clip.
FAN OPERATING INSTRUCTIONS
1. Once the fan has been assembled correctly connect the mains plug to the mains
socket.
2. To turn fan on press “ON/SPEED” on the control box or on the remote.
* When fan is on, it will start in low speed and the display shows “ ”.Repeatedly
press “ON / SPEED” to select the desired fan speed from 1 to 3.
3. To turn fan off press “OFF” on the control box or on the remote.
4. To make / stop the fan oscillate press “SWING” repeatedly
5. Tilt adjusting:
To adjust the air flow upward or downward, push the guard lightly to the desired
direction.
6. Mode
Press “MODE” repeatedly to select the desired wind mode. The corresponding light
will illuminate to show what wind mode you choose.
Normal wind Natural wind Sleep wind

4
T
7. Timer
You can set the fan to automatically turn itself on or off within a desired time period
from 0.5 to 7.5 hours.
zWhen fan is on. Repeatedly press “TIMER” on the remote to select the fan to
automatically turn itself off within a desired time period from 0.5 to 7.5 hours.
zWhen fan is off. Repeatedly press “TIMER” on the remote to select the fan to
automatically turn itself on within a desired time period from 0.5 to 7.5 hours.
This appliance is not intended for use by persons (including children) with reduced.
Physical, sensory or mental capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning use of the appliance by a
person responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance.
If the supply cord is damaged, it must be replaced by the manufacturer, its service
agent or similarly qualified persons in order to avoid a hazard.

0