Corsair Link Manual

Corsair Link Cooling & Lighting Kit.
Thank you for your purchase of Corsair Cooling & Lighting Kit.
Let’s go over the hardware included.
Hardware Content:
Corsair Link Commander with internal USB connector
1x Corsair Link Cooling Node
1x Corsair Link Lighting Node

4x Corsair Link Digital Cables
5x Fan extension Cables
3x Temperature Sensors Cable
3x RGB LED Strips
3x RGB LED Extension cables
Mounting Hardware

Hardware Installation Guide
Let’s get started!
Installing Corsair Link Commander
1. Mount the Commander inside your case to any available 5.25”HDD bay
2. (A) Locate any available USB header on your motherboard (B) Connect the USB cable
from the commander to your motherboard USB header.
(A) (B)
Installing the Cooling Node to the Commander
Note: For this installation you will need the following:
oCorsair Link Cooling Node
oCorsair Link Digital Cable
oTemperature Sensor cable
1. Mount the Cooling node anywhere on your case with the provided double-sided sticky
tape.
2. (A) Connect the Corsair Link digital cable to any one of the available 8 ports on the
commander unit. (B) Connect the other end of the Corsair Link Digital cable to your
cooling node digital port.
(A) (B)

3. You can use the temperature sensor to monitor temperatures anywhere on your case.
(A) Locate the temperature sensor ports on the cooling node. (B) Plug in the
temperature sensor cable into any one of the 4 ports.
(A) (B)
4. You can connect and control up to 5 fans per cooling node.
(A) Locate the fan ports on the cooling node. (B) Plug in your fans 3-pin or 4-pin header
into any one of the 5 ports.
(A) (B)
Installing the Lighting Node to the Commander
Note: For this installation you will need the following:
oCorsair Link Lighting Node
oCorsair Link Digital Cable
oRGB LED Extension cables
oRGB LED Strips
1. Mount the lighting node anywhere on your case with the provided double-sided sticky
tape.

2. (A) Connect the Corsair Link digital cable to any one of the available 8 ports on the
commander unit. (B) Connect the other end of the Corsair Link Digital cable to the
lighting node digital port.
(A) (B)
3. (A) Locate the male end of the RGB LED Strips. (B) Connect the male end into the
lighting node ( You may use the LED extension cables as needed)
(A) (B)
Congratulation!
Your Corsair Link Kit is fully installed and ready to go!