CKZM module extends the functionality of the CKL6230N /
CKL624N wiring centre.
The module consists of 2 additional zones with the possibility of
connecting 2 actuators to each one.
This product complies with the essential requirements and other
relevant provisions of the following EU Directives: EMC 2014/30/EU,
Low Voltage Directive LVD 2014/35/EU, RoHS directive 2011/65/EU.
Use in accordance to national and EU regulations. Use the device
as intended, keeping it in dry condition. Product for indoor use only.
Installation must be carried out by a qualified person in accordance
to national and EU regulations.
Before any of operation releated to power supply (connecting
wires, installing the device, etc.), make sure that the device is not
connected to any power source. Incorrect connection of the wires
may cause damage to the wiring centre. The module can not be
used in conditions of water vapor condensation neither exposed
to water.
The serial connector from the CKL6230N / CKL624N wiring centre
provides communication between the wiring centre and the CKZM
module.
CKL6230N / CKL624N wiring centre + CKZM module increases
functionality and additionally adds up to 8 zones to the wiring centre.
CKZM module is powered from the wiring centre.
COSMO GmbH
Brandstücken 31
22549 Hamburg
info@cosmo-info.de
www.cosmo-info.de
March 2020
V003
2-Zone Extension Module
Model: CKZM
Quick Guide
INTRODUCTION
SERIAL CONNECTOR FOR
CKZM MODULE
PRODUCT COMPLIANCE
SAFETY INFORMATION
TECHNICAL SPECIFICATION
LNLN
5
6
N N
Power Supply from the CKL6230N / CKL624N
wiring centre
Max load 0.5 A
Dimensions [mm] 80 x 80 x 20
