telescope pipe telescope pipe
screw
cover
washer nut
base
cover
screw
02 03
SAFETY INFORMATION
When using electrical appliances, basic precautions should always be
followed to reduce the risk of fire, electric shock, and injury to
persons, including the following:
1. Read all instructions before using this appliance.
2. Use fan only for purposes described in the instruction manual.
3. Those who are not qualified electricians should not disassemble,
repair or rebuild the fan.
4. This product must be grounded to reduce the risk of electric shock.
5. Do not unplug the fan by holding the cable cord. Grip plug and pull
from wall outlet. Never yank on cord.
6. Close supervision is necessary when any appliance is used by or
near children.
7. Unplug from outlet when not in use, when moving fan from one
location to another,before putting on or taking off parts and before
cleaning.
8. Avoid contact with moving parts.
9. Do not operate in the presence of explosive and/or flammable
fumes.
10. To avoid fire hazard, NEVER place the cord under rugs or any
parts near an open flame, cooking or other heating appliance.
11. Do not operate any appliance with a damaged cord or plug after
the appliance malfunctions, or has been dropped/damaged in any
manner.
12. The use of attachments not recommended or sold by the
appliance manufacturer may cause hazards.
13. Do not let the cord hang over the edge of a table counter or come
in contact with hot surfaces or leave exposed to high traffic areas.
14. Always use on a dry, level surface. Do not use the fan on the
carpet as the mist may get the flooring.
15. Do not run cord under carpeting. Do not cover cord with throw
rugs, runners, or similar coverings. Do not route cord under furniture
or appliances. Arrange cord away from traffic area and where it will
not be tripped over.
NOTE: If you feel the mist output is too strong and want to reduce the
mist output, you can either turn the valve handle counter clockwise to
reduce the water supply or change the fan speed from high to low
setting.
CAUTION: This product is intended for household use ONLY and
not for commercial or industrial applications.
Warning: Do not depend upon the on-off switch as the sole
means of disconnecting power when installing or servicing the
fan. Always unplug the power cord.
Warning: To reduce the risk of fire or electric shock, DO NOT
use this fan with any solid-state speed control device.
ASSEMBLY
1. Remove the screws, washers and nuts from accessory kit.
2. Place the Telescope Pole onto the Base, align the four screw
holes in both parts, then insert each hole with the screw and
tighten them together firmly with four washers and four nuts at
the base bottom.
