Country Living 02694000-7 User manual

OWNER’S MANUAL
Date of purchase: / /
Caution: Do not attempt to assemble if any parts are missing or damaged!
Product code: 02694000-7
UPC code: 806599112007
1/3
Collingwood High Dining Table

2/3
1
4
1
1
1
1
1
24
25
25
2
2
PARTS LIST
TABLE TOP FRAME
TABLE LEG
CONNECTOR BRACKET
(UPPER)
TILE TOP
METALWASHER
PLASTICBOLTCAP
ALLEN WRENCH
TOUCH-UPPAINT
UMBRELLA RING CAP
CONNECTOR BRACKET
(LOWER)
BOLT (M6x10mm)
BOLT (M6x20mm)

97106LI,setatsEnamffoH,noitaroproCtramKrofANIHCneohceH/niedaM
moc.tramkPOHS
stcudorpgnivilroodtuofotnemtrossaevisnetxeruoeeS
on-line at www.sears.com and www.kmart.com
:tcudorptuobastnemmocrosnoitseuqroF
Email: [email protected] or Call toll-free: 866-538-7735
Please refer to part numbers when reordering
IMPORTANT: To avoid damage to your table:
- Before storing, drain all water that may have accumulated in or around patio furniture
frames. If not drained properly, water can cause freeze damage.
- When storing patio furniture, do not stack anything on glass, stone, or marble table tops.
- An umbrella base must be used at all times if using an umbrella.
- Use of a patio furniture cover is recommended.
- For safety reasons, do not sit or stand on the table.
3/3
ASSEMBLY INSTRUCTIONS
Identify all parts packed in the carton against the parts list. Remove all protective materials. Place parts on a nonabrasive
,)1300-649-259:xaf(,5377-835-668taretneCecivreSremotsuCruollacesaelp,snoitseuqynaevahuoyfI.ecafrus
.ten.lausacemoh.wwwtaetisbewruotisivroten.lausacemoh@vrestsuc:liam-e,TSC.m.p00:5-.m.a00:9,yadirF-yadnoM
fig. 3
fig. 1
fig. 2
Step 1: Place the table frame upside down on a flat, soft place. Attach the table legs to the table top frame by inserting
the bolt M6x20mm with metal washer into the pre-drilled holes on the table top frame and legs, tighten all bolts
completely and cover them with plastic bolt caps.
Step 2: Attach the connector brackets to the table leg by inserting bolts and metal washer, DO NOT tighten completely!
Step 3: Tighten all bolts completely and cover them with plastic bolt caps. Turn the table to the upright position.
Place the umbrella ring cap into the center of table frame. Insert the tile tops into the table frame.
Your table is now ready for use
Upper connector
bracker
Lower connector
bracker