CQR PADP2/SS/G1 User manual

1
CQR PADP2 / SS /G1
Rev.1

2
Index Page
PA Overview 2
Installation Instructions 3
- Mounting 3
- Wiring 3
- Backplate Diagram 3
Operation 4
- Operating 4
- Resetting 4
Specification 4
PA Overview
Push Buttons
Front Cover
Indicator
Backplate
Key Reset Hole

3
Installation Instructions
Mounting
Undo the two cover screws to remove the front cover from the Backplate.
Fix Backplate to mounting surface using suitable fixings.
Wiring
Route the cable through the access holes in the rear of the Backplate.
Connect control panel PA zone/circuit to the two reed switch terminals inside the
PA Button (not polarity conscious) as shown below.
Refit cover to PA Backplate.
Backplate Diagram
Note: Three extra terminals are provided for terminating other circuit wires.
Connect wiring to Control
Panel PA circuit / zone
Mounting holes
Extra Terminals

4
Operation
To Operate Press both red buttons simultaneously.
Indicator will show RED.
To Reset Insert supplied key into front cover and turn clockwise
through 90°. Indicator will show Yellow. Remove key.
Note: Remove key from PA button whilst not in use and store
carefully.
Specification
Operation Double Push
Material ABS
Switch Reed
NO/NC Configuration Both
Terminals 5
Tamper None
Reset Latch
Indicator Yes
Backlit No
Max Voltage 50v DC
Max Current 500mA
Security Grade 1
Environmental Class II
Dimensions (w) x (h) x (d)mm 62 x 75 x 30