Creality CR-10 Series User manual

Installation steps
The machine is basically installed before leaving the factory,so
you only need some simple steps to install machine.
First
Taking out all parts to ensure that if they are good.Now you
must connect the Portal frame with base platform by four
screws(M5*20).

Second
1. Installing fixed block and limit switch.The limit
switch is installed on the left.The other is installed
on the right.

2.wiring
1：X axis
2：Y axis
3：Z axis
4：E axis
①：X-axis limit switch ②：Y-axis limit switch
③：Z-axis limit switch

Completely
There are two Voltage to choice--110V and
220V.Before you turn on the power,you must choice
the true Voltage.