Creative Outlier One User manual

Creative Outlier Air
Mobile Device Bluetooth Connectivity
Initial Pairing:
1. The first ear bud removed from the case will be the main unit. The remaining
ear bud will be the secondary unit. Once removed from the charging case,
the main unit will auto-switch to Bluetooth Pairing mode (LED will flash
in Red & Blue).

2. Enable Bluetooth on your mobile device to initiate pairing. In the event where
you have taken the right ear bud out first, the main unit will appear on your
device as "Outlier Air R". Tap on it to start the pairing process.
When connecting to a mobile device, always select "Pair" or "Connect" when
prompted. This will ensure that the secondary unit will also be registered/paired
with the mobile device.
In iOS, "Headset" is used to reference to the secondary unit.
Android devices, on the other hand, use the term "Outlier Air L" or "Outlier Air R"
to refer to the secondary unit.

Once the connection has been made, the secondary unit will auto-pair to
the main unit. Your device will then prompt for confirmation on the connection
made. No further action required.
Note: Do not attempt to pair your device to the secondary unit via Bluetooth.

Pairing with a new Bluetooth device:
To pair a new Bluetooth device, follow the steps below:
1. Switch OFF the Bluetooth on the previously paired Bluetooth device to disable
the connection made (or remove 'Outlier Air L/R' from the paired Bluetooth list of
your Bluetooth device.).
2. On your main unit, press and hold the Multifunction button for 3 seconds to
initiate Bluetooth Pairing mode.

3. Once it is in pairing mode, attempt pairing on the new Bluetooth device.
Note: Once the ear buds are connected and start playing audio, the LED lights will
power OFF. The LED lights on the ear buds will be flashing Blue when audio is
paused.