Cree XSP Series User manual

XSP Series
XSPR™ LED Street Light
Back Light Shield
1 of 2 LPN00259X0001A1_A
INSTALLATION INSTRUCTIONS
INSTRUCTIONS D’INSTALLATION
IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety precautions
should always be followed including the following:
READ AND FOLLOW ALL SAFETY
INSTRUCTIONS
1. DANGER- Risk of shock- Disconnect power before
installation.
DANGER – Risque de choc – Couper l’alimentation
avant l’installation.
SAVE THESE INSTRUCTIONS FOR
FUTURE REFERENCE
TO INSTALL:
1
PREPARATION
STEP 1:
Clean the surface of the LED Module.
NOTE: Be sure to use a very mild
detergent. Damage will occur to the
LED Optics if any alcohol based or
otherwise harsh chemicals used.
4 OPTIC BACK LIGHT SHIELD
STEP 1:
Back Light Shield and the metal
backlight shield frame are factory
installed together but if the assembly
comes loose in shipping reattach by
inserting (3) studs on the backlight
shield into the designated holes on
the metal frame. Push together until it
snaps into place. See Figure 1.
STEP 2:
Insert at an angle, the small tab on
the Back Light Shield Assembly in
between the grommet and grommet
shield. See Figure 1 and 2.
STEP 3:
Press the (2) large tabs on the Back
Light Shield Assembly inward and
snap them down into the luminaire
fins. See Figure 2.
2Small Tab
Grommet
Grommet Shield
(2) Large Tab
Luminaire Fin
(2) Large Tab
Small Tab
Back Light
Shield
Metal Back Light
Shield Frame

2 of 2 LPN00259X0001A1_A
www.cree.com/lighting
© 2014 Cree, Inc. All rights reserved. For informational purposes only. Content is subject to change.
See www.cree.com/lighting for warranty and specifications. Cree® and the Cree logo are registered
trademarks, and XSPR™ is a trademark of Cree, Inc.
3 OPTIC BACK LIGHT SHIELD
STEP 1:
Ensure that the orientation of the backlight
has the eyelets pointing away from the
luminaire base and carefully place on the
surface of the LED Module. See Figure 3.
STEP 2:
Snap the Back Light Shield tabs (4) into the
LED Module. See Figure 4.
NOTE: If LED Module doesn’t allow for
tabs to snap in, place supplied double
sided tape onto the recessed rectangle
located in the middle of the back side
of the shield. Once tape is placed on the
shield, firmly press shield down onto LED
Module.
3
4
Eyelets
Luminaire Base
LED Module
Eyelets
Back Light
Shield Tabs (4)
Back Light Shield