Cree OSQ HO Series User manual

OSQ HO Series
LED Area Light
Bird Spike
1 of 2 LPN00520X0001A0_A
INSTALLATION INSTRUCTIONS
INSTRUCTIONS D’INSTALLATION
IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety precautions should always be
followed including the following:
READ AND FOLLOW ALL SAFETY
INSTRUCTIONS
1. DANGER- Risk of shock- Disconnect power before installation.
DANGER – Risque de choc – Couper l’alimentation avant l’installation.
SAVE THESE INSTRUCTIONS FOR
FUTURE REFERENCE
TO INSTALL:
1
BIRD SPIKES
STEP 1:
Bring the Bird Spike assembly to the top of the
luminaire. See Figure 1.
STEP 2:
Locate the 4 clips on the Bird Spike and insert each clip
into the hole on the top side of the housing shown in
Figure 2.
STEP 3:
Push down on the raised flat surface of the clip to
extend the clip to the under edge of the housing. See
Figure 3 on the back page.
STEP 4:
Pull clip flush with housing bottom ridge. (clips do not
automatically engage housing ridge by themselves. See
Figure 4 on the back page.
STEP 5:
Release raised flat surface of clip to engage clip. See
Figure 5 on the back page.
Clips (4)
2
Insert Here
Clip
Clip
Insert Here

2 of 2 LPN00520X0001A0_A
www.lighting.cree.com
© 2017 Cree, Inc. All rights reserved. For informational purposes only. Content is subject to change.
See http://lighting.cree.com/warranty for warranty and specifications. Cree®is a registered trademark, and the Cree logo
is a trademark of Cree, Inc.
3 4
5
Push Down on
Flat Surface
Housing Bottom
Ridge
Housing Bottom
Ridge
Housing Bottom
Ridge
Pull Latch Outwards
Release Latch Upwards to
Catch Housing Ridge