Cres Cor H138NPSCDOMMQ Series Manual

5925 Heisley Road • Mentor, OH 44060-1833
Holding Cabinet FL-2331-DOM
Rev. 10 (12/11) Page 1 of 8
Cabinet model number:
Cabinet serial number:
Authorized Service Agency:
Ph: Fax:
Keep this manual for future reference.
H138NPSCDOM2MQ H138NPSCDOM3MQ
OPERATING and MAINTENANCE INSTRUCTIONS
Models: H138NPSCDOMMQ Series Hot Cabinet

5925 Heisley Road • Mentor, OH 44060-1833
Holding Cabinet FL-2331-DOM
Rev. 10 (12/11) Page 2 of 8
ELECTRICAL SPECIFICATIONS:
Model No. Volts Watts Amps Hertz Phase NEMA
H138NPSCDOM2 120 1400 11.7 60 1 5-15P
H138NPSCDOM3 120 2000 16.6 60 1 5-20P
Note: The above model numbers are basic models. They may be followed by letters: GA, L, R, 2M, D, or ending with S.
INSTALLATION:
1. Remove all paper and packing material from
inside of cabinet.
2. Remove protective paper and vinyl material from
outside surfaces of cabinet.
3. Place the cabinet in a well-ventilated area.
4. Place cabinet on level oor.
5. Plug cord end into proper wall outlet.
FIRST TIME START-UP:
1. Push the POWER switch to “ON”, and run the
unit for one hour.
NOTE: DO NOT PUT FOOD INTO CABINET!
This step is to burn off manufacturing oils and excess
adhesive.
2. Let the cabinet cool and wipe inside clean with
detergent and hot water before rst use. Blower inlet guard must be in place before
operating cabinet.
WARNING
OPERATING and MAINTENANCE INSTRUCTIONS
Models: H138NPSCDOM Series Hot Cabinet
HOW TO HOLD:
1. Push POWER switch to “ON.” POWER LIGHT
will come on.
2. The control is preset to maintain an average of
180°F. Displayed temperatures will change during
loading and unloading of product
3. Put product into cabinet.
NOTE: Proper food holding temperature is
140°F/60°C or higher.
WARNING Air is VERY HOT
when door is opened.
TEMPERATURE
CONTROL
POWER
LIGHT POWER SWITCH
ADJUST
BUTTONS
"SET" BUTTON
TEMPERATURE
DISPLAY
ADJUST
°F
SET

5925 Heisley Road • Mentor, OH 44060-1833
Holding Cabinet FL-2331-DOM
Rev. 10 (12/11) Page 3 of 8
WARNING
BEFORE cleaning the cabinet:
1. Unplug the cabinet from the wall.
2. Allow cabinet to cool.
1. Do NOT use abrasives (steel wool) or harsh
chemicals (chlorine, bromine, iodine or ammonia).
2. Do NOT use a water sprayer (pressure sprayer) to
clean the cabinet.
Cleaning hints:
1. Wipe up spills as soon as possible.
2. Clean cabinet daily to avoid heavy dirt build-up.
3. Make a test spot with cleaner:
a) Follow manufacturer’s directions on cleaner.
b) Do not mix cleaners.
c) Avoid drips and splashes.
WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK,
DO NOT REMOVE COVER (OR BACK)
NO USER-SERVICEABLE PARTS INSIDE
REPAIR SHOULD BE DONE BY AUTHORIZED SERVICE
PERSONNEL ONLY
RISK OF FIRE OR ELECTRIC SHOCK
DO NOT OPEN
WARNING
HOW TO CLEAN THE UNIT:
Soil Cleaner Method
CABINET
Inside and
Outside
(Stainless Steel)
DAILY CLEANING Mild detergent and hot
water.
1. Sponge on with cloth.
2. Rinse with water.
3. Wipe dry.
STUBBORN SPOTS AND
STAINS
Mild abrasive made for
stainless steel.
1. Apply with damp sponge or cloth.
2. Rub lightly.
3. Rinse with water and wipe dry.
BURNT-ON FOODS OR
GREASE
Chemical oven cleaner for
stainless steel.
Follow oven cleaner manufacturer’s
directions.
HARD WATER SPOTS
and SCALE Vinegar 1. Swab or wipe with cloth. 2. Rinse and dry.
*Mild detergents include soaps and non-abrasive cleaners.
Note: Gaskets are removable for cleaning.
MAINTENANCE INSTRUCTIONS

5925 Heisley Road • Mentor, OH 44060-1833
Holding Cabinet FL-2331-DOM
Rev. 10 (12/11) Page 4 of 8
FAILURE POSSIBLE CAUSE
1. POWER LIGHT (Yellow) does NOT light. 1a. Switch is “OFF”.
1b. Cord unplugged from wall outlet.
1c. Circuit breaker/fuse to wall outlet tripped/blown.
2. Unit does not heat. 2a. Temperature control is set too low.
2b. Switch is “OFF”.
3. Unit gets too hot or won’t shut off. 3a. Defective electrical parts.
UNPLUG UNIT FROM WALL OUTLET.
4. Blower does not work or makes noise. 4a. Defective blower.
5. GFCI device trips. 5a. The insulation inside the heating element may
have absorbed some moisture. This may have
occurred if the cabinet has not been used for a long
period of time or during shipping and storage of the
cabinet. Plug the cabinet into a non-GFCI outlet and
set the temperature control to its maximum. Let the
cabinet run for about 1 hour to dry out the heating
element from any moisture may have been absorbed.
If the circuit breaker trips, call the factory Authorized
service agent. After drying the heating element, plug
cabinet into the GFCI receptacle; the cabinet should
run properly. If the GFCI device continues to trip, call
the factory Authorized service agent.
GFCI (ground-fault circuit interrupter): A GFCI receptacle is a device that de-energizes a circuit when it
detects an unsafe ow of current to ground. The intention of a GFCI device is to minimize the potential for an
electrical shock.
If cause is none of the above, refer to our list of Authorized Service Centers, FL-1400
TROUBLE-SHOOTING

5925 Heisley Road • Mentor, OH 44060-1833
Holding Cabinet FL-2331-DOM
Rev. 10 (12/11) Page 5 of 8
REPLACEMENT PARTS
Include all information on nameplate when ordering parts
ITEM DESCRIPTION 120V
1 Blower Kit 0769-180-01-ALK
2Heater Kit, Air 1370 Watt 0811-289
1850 Watt 0811-022-K
3 High Limit 0848-060
4 Power Switch 0808-116-K
5 Power Light 0766-094
Relay - Solid State (not shown) 0857-130
7 Temperature controller 0848-075-DOM
8Transformer (used with Temp controller) 0769-159
9 Terminal Block (4 pole) 0852-093
Terminal Block (2 pole) 0852-091
10 Vent Fan 0769-165
Power Cord (not shown) 15 Amp 0810-029-06
20 Amp 0810-065-14-K
11 Fan Guard 0769-167
12 Cord Bracket 0553-757
13 Strain Relief 90° 0818-095
1
1
2
3
4
5
7
8
910
11
12
13
x:engineer\flsheets\FL2331rear panel

5925 Heisley Road • Mentor, OH 44060-1833
Holding Cabinet FL-2331-DOM
Rev. 10 (12/11) Page 6 of 8
CABINET REPLACEMENT PARTS:
Item Description Part No. Item Description Part No.
1 Caster 0569-306-K 8 Door, front 1221-564
2 Caster with brake 0569-306-BK 9 Door, back 1221-565
3 Gasket, doors 0861-264 10 Handle, door 0911-099-AB
4 Post, wire angle 0696-169 11 Window, wide 0574-133
5 Wire angle Set of 2 0621-281-K 12 Window, narrow 0574-155
6 Wire shelf 1170-005 13 Hinge, Kit, lift off 0519-087-K
7 Wire blower inlet guard 1170-211 14 Air Tunnel 0546-142
1
2
3
4
5
6
7
8
9
10
10
11
12
13
14
REPLACEMENT PARTS
Include all information on nameplate when ordering parts

5925 Heisley Road • Mentor, OH 44060-1833
Holding Cabinet FL-2331-DOM
Rev. 10 (12/11) Page 7 of 8
CABINET REPLACEMENT PARTS: H138NPSCDOM3
Item Description Part No. Item Description Part No.
1 Caster 0569-306-K 11 Door, back, window 1221-550
2 Caster with brake 0569-306-BK 12 Handle, door 0911-111
3 Gasket, front doors 0861-245 13 Latch, door 1006-120-01-K
4 Gasket, back door 0861-246 14 Window, wide 0574-133
5 Post, rack 0696-228 15 Window, narrow 0574-144
6 Angle, Wire, set of 2 0621-281-K 16 Hinge Kit, lift off, set of 2 0519-087-K
7 Wire shelf 1170-005 17 Hinge, butt type 0519-089
8 Wire blower inlet guard 1170-211 18 Air tunnel 0546-120
9 Door, front, window 1221-535-01 Door stop 0553-740
10 Door, front, solid 1221-534
REPLACEMENT PARTS
Include all information on nameplate when ordering parts
1
2
3
4
5
67
8
9
10
11
12
13
14
15
18
17
16

5925 Heisley Road • Mentor, OH 44060-1833
Holding Cabinet FL-2331-DOM
Rev. 10 (12/11) Page 8 of 8
WIRING DIAGRAM
*FOR TWISTLOCK OPTION
BLACK
WHITE
TEMPERATURE
CONTROL
WAC
AC
NO B
C
t°
TRANSFORMER
110V/220
4
3
2
8
1
5
BLOWER
MOTOR
VENT
FAN
VENT
FAN
BLOWER
MOTOR
PILOT LIGHT
5-20P
120V, 20A
OR L5-20P*
WHITE
BLACK
GREEN
G
HIGH LIMIT
HEATER AIR
5-15P
120V, 15A
OR L5-15P*
G
10
5
9
4
SOLID STATE RELAY
L1 T1
A2 A1
HIGH LIMIT
PWR SWITCH
1
1
2
2
10 12 13
14
13
14
15
16
25
26
15
25
12
16
26
9
7
8
20 19
22
6
5
3
7
8
19
3
20
4
W
G
W
G