Crestron DMC-C User manual

DMC-C
DigitalMedia 8G+™Input Card for DM®Switchers
crestron.com |800.237.2041
>Modular input card for a DM-MD8X8, DM-MD16X16, or
DM-MD32X32 switcher
>Provides a single DM 8G+™input
>HDBaseT®Certified
>Enables distribution of HD signals up to 330 ft (100 m) over a
single CAT5e [1]
>Handles video resolutions up to Full HD 1080p and 2K DCI
>Handles computer resolutions up to UXGA and WUXGA
>Handles 3D video and Deep Color
>Handles Dolby®TrueHD, DTS-HD®, and uncompressed 7.1 linear
PCM audio
>HDCP compliant
>Includes an HDMI®output for pass-through of the input signal
>Includes a stereo analog line-level audio output with
volume control [3]
>Allows extraction of stereo 2-channel audio signals
>Supports PoDM and PoH [2]
>Occupies a single input card slot
>Provides a rack-mountable DM 8G+ receiver solution using the
optional DMCI card interface [4]
The DMC-C is an input card designed for use with any card-based
Crestron®DigitalMedia™Switcher. It provides one DM 8G+™input, with
associated HDMI®pass-through and analog audio outputs. The DM 8G+
input enables the connection of a DM 8G+ transmitter, the output of
another DM®switcher, or an HDBaseT®certified source. Just one CAT5e
wire is required for connection to the DM 8G+ input, supporting distances
up to 330 feet (100 m).[1] Power over DM (PoDM) is supplied over the same
CAT5e connection, providing a centralized power source for PoDM
compatible transmitters.[2]
NOTE: Refer to model DMC-C-DSP for use with surround sound sources.
DigitalMedia 8G+™
DigitalMedia 8G+ provides a true one-wire transport for moving high-
definition video, audio, power, and Ethernet over low-cost twisted-pair
cable without any compression or repeaters. Engineered for ultra high-
bandwidth and ultimate scalability, DM 8G+ handles uncompressed video
beyond high-definition with support for Full HD 1080p, 2K, 3D, Deep Color,
and HDCP. Audio capabilities include support for high-bitrate 7.1 audio
formats like Dolby®TrueHD and DTS-HD Master Audio™as well as
uncompressed linear PCM. All signals are transported over one
8-conductor twisted-pair cable, supporting distances up to 330 feet
(100 m) using Crestron DM 8G®Cable or CAT5e.[1]
HDBaseT®Certified
Crestron DigitalMedia 8G+ technology is designed using HDBaseT Alliance
specifications, ensuring interoperability with other HDBaseT certified
products. An HDBaseT compliant device can be connected directly to the
DM 8G+ input on the DMC-C without requiring a DM transmitter.
HDMI®Pass-Through
Every DM switcher input card includes an HDMI output port, which can be
used to pass the input signal through to a local audio processor or video
monitor, or to feed a second DM switcher for output expansion purposes.
Audio Extracting
The DMC-C also includes an unbalanced analog audio output, allowing
stereo audio signals to be extracted from the digital input and fed to a
multiroom audio distribution system. The output volume is adjustable via
a control system using a keypad, touch screen, handheld remote, or
mobile device.[3]
NOTE: For applications requiring the simultaneous distribution of multi-
channel surround sound and 2-channel stereo audio signals, use model
DMC-C-DSP.
Power over DM®
Power over DM (PoDM) and Power over HDBaseT (PoH) can be supplied
through the DMC-C via its DM 8G+ input port to power a compatible
DM 8G+ transmitter or HDBaseT device. To enable PoDM or PoH, simply
connect a PoDM Power Supply (model DM-PSU-8 or DM-PSU-16[4]) to the
POE IN port on the input card. As an alternative to a PoDM Power Supply,
a Crestron PoE switch, PoE injector, or other 802.3af or 802.3at compliant
PoE PSE may be used.[2]
Standalone DM 8G+ Receiver
In addition to its use as an input card for DM switchers, the DMC-C may
also be used with the DMCI DigitalMedia Card Interface[4] to provide a DM
8G+ receiver solution that’s perfect for installation in an equipment rack or
AV cart, or as a portable display interface.
To configure a DM switcher complete with input and output cards,
cables, and other peripherals, please use the online DigitalMedia
Switcher Configuration Tool.
Please refer to the DigitalMedia Resources Webpage at
http://www.crestron.com/dmresources/ for additional design tools and
reference documents.

DMC-C DigitalMedia 8G+™Input Card for DM®Switchers
crestron.com |800.237.2041
SPECIFICATIONS
Video
Input Signal Types: DM 8G+™(DigitalMedia over one CAT5e twisted-pair
copper wire), HDBaseT®[1]
Output Signal Types: HDMI®or DVI[5] to switcher backplane and HDMI OUT
connector
Formats: DM 8G+, HDBaseT, & HDMI with Deep Color & 3D; HDCP content
protection support
Input Resolutions, Progressive: 640x480@60Hz, 720x480@60Hz
(480p), 720x576@50Hz (576p), 800x600@60Hz, 848x480@60Hz,
852x480@60Hz, 854x480@60Hz, 1024x768@60Hz, 1024x852@60Hz,
1024x1024@60Hz, 1280x720@50Hz (720p50), 1280x720@60Hz
(720p60), 1280x768@60Hz, 1280x800@60Hz, 1280x960@60Hz,
1280x1024@60Hz, 1360x768@60Hz, 1365x1024@60Hz,
1366x768@60Hz, 1400x1050@60Hz, 1440x900@60Hz, 1600x900@60Hz,
1600x1200@60Hz, 1680x1050@60Hz, 1920x1080@24Hz (1080p24),
1920x1080@25Hz (1080p25), 1920x1080@50Hz (1080p50),
1920x1080@60Hz (1080p60), 1920x1200@60Hz, 2048x1080@24Hz,
2048x1152@60Hz, plus any other resolution allowed by HDMI up to
165MHz pixel clock
Input Resolutions, Interlaced: 720x480@30Hz (480i), 720x576@25Hz
(576i), 1920x1080@25Hz (1080i25), 1920x1080@30Hz (1080i30), plus
any other resolution allowed by HDMI up to 165MHz pixel clock
Output Resolutions: Matched to input
Audio
Input Signal Types: DM 8G+, HDBaseT
Output Signal Types: HDMI (multi-channel) to switcher backplane and
HDMI OUT connector, analog stereo 2-channel[3], allows audio breakaway
Digital Formats: Dolby Digital®, Dolby Digital EX, Dolby Digital Plus,
Dolby®TrueHD, DTS®, DTS-ES, DTS 96/24, DTS-HD High Res,
DTS-HD Master Audio™, up to 8ch PCM
Analog Formats: Stereo 2-channel
Digital-To-Analog Conversion: 24-bit 48 kHz
Performance (analog): Frequency Response: 20Hz to 20kHz ±0.5dB;
S/N Ratio: >95dB, 20Hz to 20kHz A-weighted;
THD+N: <0.005% @ 1kHz;
Stereo Separation: >90dB
Volume Gain Range (analog): -80dB to 0dB
Connectors
HDMI OUT: (1) 19-pin Type A HDMI female;
HDMI digital video/audio output;
Also supports DVI[5]
DM IN: (1) 8-pin RJ45 female, shielded;
DM 8G+ input, HDBaseT compliant;
PoDM and PoH PSE (Power Sourcing Equipment) port[2];
Connects to the DM 8G+ output of a DM transmitter or other DM device, or
to a HDBaseT device, via CAT5e or Crestron DM-CBL-8G DigitalMedia 8G™
Cable[1]
POE IN: (1) 8-pin RJ45 female, PoE input;
Connects to a DM-PSU-8 or DM-PSU-16 PoDM Power Supply, or to an
802.3af or 802.3at compliant PoE PSE (Power Sourcing Equipment), to
enable PoDM and PoH power sourcing[2]
AUDIO OUT: (2) RCA female;
Unbalanced stereo line-level audio output[3];
Output Impedance: 100 Ohms nominal;
Maximum Output Level: 2 Vrms
Indicators
DM IN: (2) LEDs, green LED indicates DM link status, amber LED indicates
video and HDCP signal presence
Construction
Plug-in card, occupies (1) DM Switcher input card slot, includes metal
faceplate w/black finish
Weight
8.0 oz (227 g)
MODELS & ACCESSORIES
Available Models
DMC-C: DigitalMedia 8G+™Input Card for DM®Switchers
Available Accessories
DM-PSU-8: 8-Port PoDM Power Supply for DM®Switchers
DM-PSU-16: 16-Port PoDM Power Supply for DM®Switchers
DM-CBL-8G-NP: DigitalMedia 8G™Cable, non-plenum
DM-CBL-8G-P: DigitalMedia 8G™Cable, plenum
DM-8G-CONN: DigitalMedia 8G™Cable Connector
DM-8G-CRIMP: Crimping Tool for DM-8G-CONN
DM-8G-CONN-WG: DigitalMedia 8G™Cable Connector with Wire Guide
DM-8G-CRIMP-WG: Crimping Tool for DM-8G-CONN-WG
CBL Series: Crestron®Certified Interface Cables
MP-WP Series: Media Presentation Wall Plates
MPI-WP Series: Media Presentation Wall Plates - International Version
DMCI: DigitalMedia™Card Interface

DMC-C DigitalMedia 8G+™Input Card for DM®Switchers
Crestron Electronics, Inc. 15 Volvo Drive |Rockleigh, NJ 07647
Tel: [phone] |Fax: [phone]
www.crestron.com
All brand names, product names and trademarks are the property of their respective owners.
©2014 Crestron Electronics, Inc.
Specifications subject to change without notice. Revised 05/29/14
Notes:
1. The maximum cable length for DigitalMedia 8G+ (DM 8G+) or HDBaseT is 330 ft (100 m)
using DM-CBL-8G DigitalMedia 8G cable, DM-CBL DigitalMedia Cable, DM-CBL-D
DigitalMedia D Cable, or third-party CAT5e (or better) UTP or STP. Shielded cable and
connectors are recommended to safeguard against unpredictable environmental electrical
noise which may impact performance at resolutions above 1080p. Refer to the Crestron
DigitalMedia Design Guide, Doc. #4546 for complete system design guidelines. DM 8G+ is
compatible with HDBaseT Alliance specifications for connecting to HDBaseT compliant
equipment. All wire and cables sold separately.
2. Supplying Power over DM (PoDM) or Power over HDBaseT (PoH) via the DM IN port requires
connection of the DMC-Cís POE IN port to a PoDM Power Supply (DM-PSU-8 or DM-PSU-16,
sold separately) or an 802.3af or 802.3at compliant PoE PSE. Refer to the connected DM 8G+
or HDBaseT device for its PoDM or PoH capabilities and requirements.
3. The analog stereo audio output is only active when the input source is outputting a 2-channel
stereo signal. For applications using a multichannel surround sound source, use model
DMC-C-DSP which provides simultaneous surround sound and stereo downmix output signals.
4. Item(s) sold separately.
5. DVI is supported via the HDMI output using a suitable adapter or interface cable. CBL-HD-DVI
interface cable available separately.
This product may be purchased from an authorized Crestron dealer. To find a dealer, please
contact the Crestron sales representative for your area. A list of sales representatives is available
online at www.crestron.com/salesreps or by calling 800-237-2041.
The specific patents that cover Crestron products are listed online at: patents.crestron.com.
Crestron, the Crestron logo, DigitalMedia, DigitalMedia 8G, DigitalMedia 8G+, DM, DM 8G, and
DM 8G+ are either trademarks or registered trademarks of Crestron Electronics, Inc. in the
United States and/or other countries. Dolby and Dolby Digital are either trademarks or registered
trademarks of Dolby Laboratories in the United States and/or other countries. DTS, DTS-HD, and
DTS-HD Master Audio are either trademarks or registered trademarks of DTS, Inc. in the United
States and/or other countries. HDBaseT and the HDBaseT Alliance logo are either trademarks or
registered trademarks of the HDBaseT Alliance in the United States and/or other countries. HDMI
and the HDMI Logo are either trademarks or registered trademarks of HDMI Licensing LLC in the
United States and/or other countries. Other trademarks, registered trademarks, and trade names
may be used in this document to refer to either the entities claiming the marks and names or their
products. Crestron disclaims any proprietary interest in the marks and names of others. Crestron
is not responsible for errors in typography or photography. Specifications are subject to change
without notice. ©2014 Crestron Electronics, Inc.