Crestron DigitalMedia DM-RPP-K24 User manual

DO GUIDE
Side View
Front View
NOTE: Use the included front panel label strip to label each port.
DM-RPP-K24
DigitalMedia™ 24-Port Keystone Patch Panel
DO Install the Patch Panel
The Crestron®DM-RPP-K24 occupies 1 RU of rack space. Mount the patch panel into the rack,
and then attach the patch panel to the rack rails using the included mounting hardware.
Rack Mounting
DO Connect the Patch Panel
Connect the patch panel as shown in the following illustrations.
Rear View
DO Check the Box
QTY PRODUCT PART NUM.
1Accessory Kit Containing (1) Front Panel Label Strip
and Holder, (25) 4" Cable Ties, (1) Mounting Hardware
Kit, and (1) Grounding Hardware Kit
2046518
Not Included: Phillips Screwdriver, Small Flat-head Screwdriver
From up to
24 DM-CONN-ULTRA-RECP RJ45 Jacks
(2) Threaded Insert for Included Ground Lug
(Use Left or Right Insert)
Removal of DM-CONN-ULTRA-RECP from Patch Panel
OR
Installation of DM-CONN-ULTRA-RECP into Patch Panel
From up to
24 DM-CBL-ULTRA-PC Patch Cables
(Connect to DM-CONN-ULTRA-RECP
RJ45 Jacks)

DO GUIDE DOC. 7796A (2045261) 05.16
Specications subject to change without notice.
DO Manage the Cables
Manage the cables as shown in the following illustration.
Cable Management
DO Learn More
Visit the website for additional information. To learn more about this product, use a
QR reader application on your mobile device to scan the QR image.
Crestron Electronics
15 Volvo Drive, Rockleigh, NJ 07647
888.CRESTRON | www.crestron.com
As of the date of manufacture, the product has been tested and found to comply with specications for CE marking.
This product is Listed to applicable UL Standards and requirements by Underwriters Laboratories Inc.
The specic patents that cover Crestron products are listed at http://www.crestron.com/legal/patents. The product warranty can be found at www.crestron.com/warranty.
Certain Crestron products contain open source software. For specic information, please visit www.crestron.com/opensource.
Crestron, the Crestron logo, and DigitalMedia are either trademarks or registered trademarks of Crestron Electronics, Inc. in the United States and/or other countries. UL and the UL logo are
either trademarks or registered trademarks of Underwriters Laboratories, Inc. in the United States and/or other countries. Other trademarks, registered trademarks, and trade names may be
used in this document to refer to either the entities claiming the marks and names or their products. Crestron disclaims any proprietary interest in the marks and names of others. Crestron is
not responsible for errors in typography or photography.
This document was written by the Technical Publications department at Crestron.
©2016 Crestron Electronics, Inc.
(24) T-Slot for
Cable Management
(Use Included Cable Ties)