Trim Ring Mount Kits Crestron TMK-3000L & WMKT-3000L
4. Run the necessary cables for the touchpanel and secure them behind the
drywall.
5. The TPS-3000L can be installed using the four tapped holes in the
PMK-3000L or BB-3000L. Refer to the latest revision of the
TPS-3000L Operations Guide (Doc. 6077) for details.
WMKT-3000L Procedure
The procedure in this section provides the necessary steps for installation of the
WMKT-3000L into a wall. Complete the steps in the order provided. The only tools
or materials required and not supplied are a drywall saw or equivalent and a level.
1. Locate an area on the wall that is free of miscellaneous wiring and
studs.
2. Make a small hole near the middle of the designated site; verify that the
location is suitable.
NOTE: Make the cutout as level and smooth as possible. The mounting plate allows
for only minor leveling adjustments. If a larger cutout is accidentally made, consider
purchasing the Crestron Mud Mount Kit, MMK-3000L. It and the mounting plate
supplied with the WMKT-3000L provide a cost-effective means of correction.
Essentially, The combination of these two kits makes up the Crestron Mud Mount
Kit for the Wall, WMKM-3000L. Simply follow the “WMKM-3000L Procedure” in
the latest revision of the Mud Mount Kits Installation Guide (Doc. 6021).
3. Use the drywall saw or equivalent to produce a level, rectangular cutout
in the drywall (refer to the Drywall Cutout dimensions on page 2 for
cutout dimensions.).
4. Insert the symmetrical trim plate into the opening, as shown in the
illustration after this step.
Insert the Trim Plate into the Opening
IMPORTANT:
PLEASE MAKE DRYWALL CUTOUT AS
LEVEL AND CLEAN AS POSSIBLE.
THE MOUNTING PLATE ALLOWS FOR
ONLY MINOR ADJUSTMENT OF TPS-3000L.
TRIM PLATE
DRYWALL
MOUNTING PLATE
5. Carefully pass the mounting plate through the opening and rest it
against the interior surface of the drywall.
4 •Trim Ring Mount Kits: TMK-3000L & WMKT-3000L Installation Guide – DOC. 6020
