Crestron ULTIMATE IGS12T-PRIMED-EACH User manual

The Crestron® ULTIMATE IGS12T-PRIMED-EACH in-ground subwoofer
made by Origin Acoustics provides the full impact of your music
outdoors with rich and deep bass. Its compact, watertight enclosure
installs beneath the ground’s surface, affording a virtually hidden
appearance with just the port tube and dome visible. The port tube is
topped with a primed, paintable dome-shaped cap, providing a subdued
appearance.
In the Box
1 ULTIMATE IGS12T-PRIMED-EACH
 
Additional Items
1 Dome
2 Wire Nuts
Installation
Prepare the Site
1. Choose a location that will not flood and where the port tube and
dome will not be affected by an in-ground sprinkler system. The
installation must comply with all national and local codes.
ULTIMATE IGS12T-PRIMED-EACH QuickStart
Ultimate 12 in. In-Ground Subwoofer, Primed Paintable, Single
1

2. Dig a hole with minimum dimensions to bury the speaker:
lHeight: 15-17 in. (381-432 mm)
lDiameter: 22 in. (559 mm)
3. Prepare a flat bed for the subwoofer that is free of voids and large
rocks (see Figure B).
NOTE: The hole must be deep enough to allow a 2 to 4 in. (51 to 102
mm) layer of material (sand and gravel mix or other material
approved by local codes) and position the base of the speaker 15 to
17 in. (381 to 432 mm) below ground level.
2
ULTIMATE IGS12T-PRIMED-EACH QuickStart
Ultimate 12 in. In-Ground Subwoofer, Primed Paintable, Single

Mount the Subwoofer
1. Remove the tap cap and rotate the dial to the 70V/100V or 8 Ohm
tap selection and then firmly reinstall the tap cap (see Figure A).
NOTE: Make sure the desired tap selection is done on the subwoofer
before lowering it into the ground.
2. Place the subwoofer into the ground.
NOTE: Ensure that the bottom of the dome is about 4 in. (102 mm)
above ground level – it should not be buried or set at ground level.
3. Dig a 5 in. (127 mm) deep trench to run the speaker cable in. Make
sure trenching is done as per local codes.

Connect the Speaker Cable
1. Run the speaker cable (not included) from theaudio source to the
wire nut, observing all appropriate local codes.
2. Run the speaker cable from the speaker location to the wire nut,
observing all appropriate local codes.
NOTES:
lThe speaker includes a hardwired direct-burial speaker cable.
lMake sure that the positive cable is attached to the red
connection, and the negative cable is attached to the black
connection.
3. Combine and twist the positive (+) cables together in a clockwise
motion. Repeat this step for the negative (-) cables.
4. Secure the two cables together using the wire nuts ensuring that NO
COPPER is exposed.

3
ULTIMATE IGS12T-PRIMED-EACH QuickStart
Ultimate 12 in. In-Ground Subwoofer, Primed Paintable, Single

Visit the Product Page
Scan the QR code to visit the product page.
ULTIMATE IGS12T-PRIMED-EACH
https://www.crestron.com/model/6511871

Additional Information

Original Instructions
The U.S. English version of this document is the original instructions.
All other languages are a translation of the original instructions.
Regulatory Model: M202046012
Crestron product development software is licensed to Crestron dealers and Crestron
Service Providers (CSPs) under a limited nonexclusive, nontransferable Software
Development Tools License Agreement. Crestron product operating system software is
licensed to Crestron dealers, CSPs, and end-users under a separate End-User License
Agreement. Both of these Agreements can be found on the Crestron website at
www.crestron.com/legal/software_license_agreement.
The product warranty can be found at www.crestron.com/warranty.
The specific patents that cover Crestron products are listed at
www.crestron.com/legal/patents.
Certain Crestron products contain open source software. For specific information, visit
www.crestron.com/opensource.
Crestron and the Crestron logo are either trademarks or registered trademarks of
Crestron Electronics, Inc. in the United States and/or other countries. Origin Acoustics is
either a trademark or registered trademark of Origin Acoustics, Inc. in the United States
and/or other countries. Other trademarks, registered trademarks, and trade names may
be used in this document to refer to either the entities claiming the marks and names or
their products. Crestron disclaims any proprietary interest in the marks and names of
others. Crestron is not responsible for errors in typography or photography.

©2021 Crestron Electronics, Inc.
Doc. 9041A
08/18/21
4
ULTIMATE IGS12T-PRIMED-EACH QuickStart
Ultimate 12 in. In-Ground Subwoofer, Primed Paintable, Single