Crosley Furniture CF1325 User manual

Partition Panel Back Rail
Upper Fixed
Shelf Panel Lower Fixed Shelf Panel Back Slat

Screw
Short Screw

4
Please do not use tools to assemble this unit unless specifically indicated.
Step 1. Insert drawer left panel (part I) and drawer right panel (part J) into drawer front
panel (part H) pull down to lock. Slide drawer bottom panel (part L) into grooves
of assembled unit (parts H, I & J). Attach drawer back panel (part K) to
assembled unit (parts I, J & L) using long screws (part #2) and phillips head
screwdriver. Attach handle (part #8) to drawer front panel (part H) using round
head bolts (part #4) and phillips head screwdriver.

5
Step 2. Insert lower fixed shelf panel (part N) to partition panel (part F).
Step 3. Attach upper fixed shelf panel (part M) to partition panel (part F) using wood
dowels (part #7), screws (part #3) and phillips head screwdriver.

6
Step 4. Attach panels (parts B & C) and back rail (part G) to panels (parts F, M & N)
using wood dowels (part #7) and lock the hardware.
Step 5. Attach bottom panel (part D) to assembled unit (parts B, C, F & G) using wood
dowels (part #7), screws (part #3) and phillips head screwdriver.

7
Step 6. Attach legs (parts P & Q) to bottom panel (part D) using bolts (parts #5 & #6)
and allen wrench (part #9).
Step 7. Carefully turn unit upright. Attach back slat (part O) to back rail (part G) using
wood dowels (part #7).

8
Step 8. Insert back panels (part E) into grooves of assembled unit (parts B, C, G & O).
Step 9. Attach top panel (part A) to assembled unit (parts B, C & O) using wood
dowels (part #7) and lock the hardware.

9
Trigger
Disconnect
Lever
Slide Track
Slide Runner
Step 10. Slide assembled drawer into place.
Note: To release trigger disconnect levers push one side up and the other down.
Note: It is important to adjust levelers once fully assembled and upright. Extend
adjustable leveler until it's firmly in contact with the floor. If relocating, adjust
leveler as needed until it's firmly in contact with the floor in new Iocation.
Trigger Disconnect Lever

10
Important: Safety strap kit (part #11) must be installed to prevent tipping,
damage and /or injury.
Step 11. Secure back brackets (part #10) at the corner of back panels (part E) using
short screws (part #1) and phillips head screwdriver.

#11
Wall Anchor Short ScrewWasher D8*3/4" Safety Wall Strap
Long Screw
D8*1-1/2"
11