Crosley Furniture CF3034 User manual

Partition Panel Front Rail
Center Rail Back Rail Back Slat

3

4
Please do not use tools to assemble this unit unless specifically indicated.
Step 1. Insert drawer left panel (part I) and drawer right panel (part J) into drawer front
panel (part H) pull down to lock. Slide drawer bottom panel (part L) into grooves
of assembled unit (parts H, I & J). Attach drawer back panel (part K) to
assembled unit (parts I, J & L) using screws (part #2) and phillips head
screwdriver. Attach handle (part #10) to drawer front panel (part H) using round
head bolts (part #3) and phillips head screwdriver. Repeat for remaining drawer.

5
Step 3. Attach towel bar (part #11) to left panel (part B) using bolts (part #4) and allen
wrench (part #14).
Step 2. Attach door magnets (part #9) to center rail (part M) using round head screws
(part #1) and phillips head screwdriver.

6
Step 4. Attach locking casters (part #12) and casters (part #13) to panels (parts B & C)
using wrench (part #15).
Step 5. Attach left panel (part B) to bottom panel (part D) using wood dowels (part #7),
long bolts (part #5), barrel nuts (part #6), phillips head screwdriver and allen
wrench (part #14).

7
Step 6. Attach partition panel (part F) to bottom panel (part D) using wood dowels
(part #7) and lock the hardware.
Step 7. Attach center rail (part M) to assembled unit (parts B & F) using wood dowel
(part #7).

8
Step 8. Attach right panel (part C) to assembled unit (parts D & M) using wood dowels
(part #7), long bolts (part #5), barrel nuts (part #6), phillips head screwdriver
and allen wrench (part #14).
#6
Step 9. Carefully turn unit upright. Attach front rail (part G) to assembled unit
(parts B, C & F) using wood dowel (part #7), long bolts (part #5), barrel nuts
(part #6), phillips head screwdriver and allen wrench (part #14).

9
Step 10. Attach back slat (part O) to bottom panel (part D) using wood dowels (part #7).
Step 11. Insert back panels (part E) into grooves of assembled unit (parts B,C, D & O).

10
Step 12. Attach back rail (part N) to assembled unit (parts B,C & O) using wood dowels
(part #7), long bolts (part #5), barrel nuts (part #6), phillips head screwdriver
and allen wrench (part #14).
Step 13. Attach top panel (part A) to assembled unit (parts B, C, G & N) using wood
dowels (part #7) and lock the hardware.

F
RR
R
11
F
Step 14. Slide assembled drawers into place.
Step 15. Place shelf holders (part #8) into desired position and then slide adjustable
shelves (part R) into place.

PIN PIN PIVOT CAVITY
F
12
R
R
MM
Step 16. Attach handles (part #10) to door panels (parts P & Q) using round head bolts
(part #3) and phillips head screwdriver. Attach door panels (parts P & Q) by
placing bottom pin hinges (pre-installed in door) in the pre-drilled holes of
bottom panel (part D). Then depress the top spring-loaded pin hinge so it
can be placed in the pre-drilled holes of center rail (part M).
Note: Be sure top and bottom pin hinges are fully extended to secure doors in place.