5
INSTALLING YOUR REPLACEMENT
FILTER SYSTEM
1. Your air purifier will automatically tell you when its time to change
your filter. An icon on the control panel will illuminate after 2500
hours of purification has been reached.
2. Place the 4-sided combination H13 HEPA/Active Carbon filter on
a sturdy flat surface.
3. Slide the removable, reusable metal pre-filter that you have washed
and dried into the slots on all 4 sides of the replacement H13 HEPA/
Active Carbon filter.
4. Slide the new 4-sided filter system into the back of the unit until
you feel resistance.
5. Make sure your air purifier is plugged in and powered up.
YOU WILL NOW NEED TO RESET THE FILTER INDICATOR.
6. Reset the filter indicator light by pressing and holding down the
night light button for 3 seconds. This will reset the filter indicator
light.
MAINTENANCE AND REPLACEMENT
OF FILTERS AND UV-C LIGHT
The H13 high-grade HEPA lters could be vacuumed as needed in order
for the air purier to perform at its best. If the air purier contains dust
or pet dander, it’s best to clean the removable, reusable metal pre-lters
more often than once a month to maintain 2,500 hours of lter life.
Always unplug your air purier from the electrical outlet before replacing
or removing any lters or replacing the UV-C bulb.
Step 1. Filter Cover Panel:
The Purxium Air Purier takes in and puries air on all 4 sides.
To remove lters contained in the unit, you will remove the lter
cover panel located in the back of the air purier. Press the but-
ton located on top of the panel to release it from the base
of the unit.
Step 2. Pre-Filters and HEPA H13 Filtration Set:
You will now see the pre-lter and HEPA H13 and active carbon
lters that you will remove from the unit by placing your ngers
on the left and right side of the lter and pulling straight out.
The lters are a complete set. The pre-lters may be removed
by pulling them up through the slots.
Step 3. UV-C Light:
Follow Steps 1 and 2 for removing lters. At the base of the
unit, there is one screw that hold the cover to the UV-C bulb
compartment. Remove the screw with a screwdriver and
carefully remove the UV-C light bulb. Replace with new a
UV-C light bulb. The UV-C light bulb should be replaced
at 10,000 hours of use. Contact Cuisinart customer service
for your replacement UV-C light tube.
WARNING: Skin or eye damage may result from directly viewing the
light produced from this lamp in this apparatus. Always disconnect
before relamping or servicing. Replace lamp with Lamp Model No.: Z138,
manufactured by Zhangzhou Yingguang Electronic Technology Co., Ltd.
FEATURES AND SPECIFICATIONS
Note: The UV-C light contains mercury, which is a hazardous material.
Please use gloves when removing the bulb, place into a plastic bag
and drop off at a recycle facility near you.
This product complies with the maximum allowable concentration of
ozone of 0.050 parts per million by volume (ppmv) in a 24-h period.
Our H13 High Grade HEPA filter captures up to 99.9% of airborne
particles 0.1 Micron or larger including bacteria and various
contaminants as well as dust, pollen and odors from cooking,
smoke, pets and VOC’s. The CAP-1000C quiet DC motor has a
3-stage filtration system that purifies air in an up to 1,000-sq. ft.
area two times every hour or 500-sq. ft. area four times every hour.
