Setup: Re-pairing
Setup: Un-pairing
The doorbell has already been paired and is ready to use. However
when adding or replacing the transmitter you will need to re-pair. One
transmitter can control several receivers or several transmitters can
control one receiver, should you wish to buy additional units.
1.) Press and hold any button, on the side
of the receiver for at least 3 seconds.
2.) Press the transmitter, the receiver will
start to ring.
1.) Press and hold any button, on the side
of the receiver for at least 10 seconds.
Step 3: Install
Option 1
Option 2
1.) Remove the double sided tape
Note: Please ensure that the xing surface, is clean, dry and grease free.
2.) Stick to the wall
1.) Remove the double sided tape
and stick to the wall, secure the
xing with extra screws using the
holes provided
Step 1: Quick Setup
Step 2: Test
When you press the transmitter, the
receiver rings.
When the receiver is plugged in, the
doorbell will ring once
4 volume levels.
Over 30 dierent tunes.
