CVT Face A+ User manual

FaceA+
UserGuide
Version1.01
FA-1000/FA-2000

3.1UserAuthenticationMethods
3.2CardOnlyUserRegistration
3.3FaceOnly/FaceandUserIDUserRegistration
3.4FaceorCard/FaceandCardUserRegistration
4.1MethodsofBrowsingUsers
4.2BrowseandDeleteUsers
4.3BrowseandDeleteUser Groups
5.1MethodsofBrowsingAccessLogs
5.2Browse AccessLogs
6.1FaceAuthenticationSetting
6.2ScreenSetting
6.3SoundSetting
2.1SetUptheDevice
2.2RegistertheInitialAdministrator
1.1DeviceAppearance
1.2Components
1.3CableConnection
1.4DeviceInstallation
1.5Dimensions
1DeviceOverview&Installation …………02
Contents
2DeviceInitialization ………………………08
3UserRegistration …………………………10
4UserManagement ………………………15
5BrowsingAccessLogs ……………………18
6EnvironmentSettings ……………………19
7.1TCP/IP
7.2ManagerServerConfiguration
7.3NetworkConnectionTest
7NetworkSettings …………………………22
8MealCount ………………………………25
9TimeandAttendance ……………………26
10 TroubleShootingGuide …………………27

ColorCamera IRCamera
Microphone
Speaker
RFCard
AuthenticationUnit
(ISO/IEC14443AMifare)
Front
LCDTouchPanel
2
DeviceAppearance
1DeviceOverview&Installation
1.1

Back
USBOTG
(USBMemory)
1
2
3
4
4
3
2
15
▶PowerConnector
112V
2GND
3NotUsed
4NotUsed
▶Door-LockConnector
1EXITButton (Input)
2EXITButton (GND)
3NotUsed
4Relay(NO)
5Relay(COM)
3
LAN (RJ45)
USBHost
DeviceAppearance
1.1

FaceA+
Wall-Mount
Bracket
4screwsforfixing
bracketonthewall
1screwforfixingthe
readerontothebracket
4
PowerCable
Door-LockCable
▶PowerCablePin-Map
1Red:12V
2Black:GND
3Notused
4Notused
▶Door-LockCablePin-Map
1Yellow:EXITButton (Input)
2Yellow:EXITButton(GND)
3NotUsed
4Black:Relay(NO)
5Black:Relay(COM)
AdapterCable ▶AdapterCablePin-Map
1Red:12V
2Black:GND
12VAdapter
Components
1.2

5
•Connectthepowercabletothe12Vadaptercable.
•Youmaycutthecableofthe12Vadaptertoconnectitdirectlytothepowercableorusean
adaptercableinthemiddle.
•Themaximumpowerconsumptionoftheproductis1Aatthepowersupplyof12V.
Terminal 1
Terminal 2
Door-LockDevice
(Deadbolt,EMLock)
12VSeparate
PowerSupply
ExitButton
ExitButton
▶Door-Lock Cable
1Yellow:ExitButton (Input)
2Yellow:ExitButton (GND)
3NotUsed
4Black:Relay(NC)
5Black:Relay(COM) EM Lock
Deadbolt
ExitButton
Exit
Button
▶ Power Cable
1Red:12V
2Black:GND
▶Door-LockCable
1Yellow:ExitButton (Input)
2Yellow:ExitButton (GND)
3NotUsed
4Black:Relay(NC)
5Black:Relay(COM)
•Thedoorlockcableisforconnectingthedoorlock(deadbolt,EMlock)andEXIT-button.
•Connecttheyellowlineofthedoorlockcableandtheexit button.
•Connecttheblacklineofthedoorlockcabletotheexitbuttonofthedoorlock.
•Thepowerofthedoorlockmustbesuppliedseparatelytosuittheratedpowerofthedoor
lock.
•Dependingonthepositionofthedoorlock,thecablemustbeextended.
•Ifyoufinishedconnectingthepoweranddoorlockcables,openthecoverontherearof
theproductandconnectthemtotheappropriateconnectors.
•Inaddition,whenconnectingtotheManagerserver,theethernetcablemustbeconnected
totheRJ45LAN-port.
•Afterconnectingthecables,organizethenclosethecover.
▶PowerCableConnection
1Red:12V
2Black:GND
1
2
3
4
5
6
9
10
11
7
8
CableConnection
1.3

FixFaceA+tothebracketwiththebracket
fixingscrew.
4
*Theoptimalheightis135cm.
*Avoidinstallingthedeviceindirectsunlight. *Powercable,doorlockcableandLANcablemust
gothroughtheholeinthebottomofthebracket.
6
135cm
DeviceInstallation
1.4
Determinethecorrectpositiontoinstall
theproduct.
1Fixthebracketfirmlywithfixingscrewsto
thepositionwhereFaceA+willbe
installed.
2
InstallFaceA+ontothebracket.
*Beforeinstallingtheproductonthebracket,
youmustopentherear coverandconnectthe
cablestotheappropriateportfirst.
3

7
FaceA+ Wall-MountBracket
Dimensions
1.5
104 mm 40 mm
154 mm
89 mm
204 mm

8
•Ifyouareinstallingthedeviceforthefirsttime,youmustsetitspurposeofuse.
•Whenturningonthedeviceforthefirsttime,thedevicesettingscreenappearsasbelow.
•Refertothetablebelowforadetailedsetup.
•Tosavethesettingvalues,pressSave.
•Aftersaving,userregistrationforinitialadministratorregistration willbegin.
(Tochangethesettingsagainaftertheinitialsetup,entertheDeviceSettingsmenuintheMainMenu.)
SettingItem Description
DeviceInfo Checkthedeviceinformation.
T&A/MealCount Thedefaultmodeisaccesscontrol;youcanchangeittotimeand
attendanceormealcount.
SyncTime SynchronizesthedevicetimewiththeInternetNTPserverortheManager
server.
DeviceNo. WhenworkingwiththeManagerserver,assignauniquenumberfor
individualdevicecontrol.
Camera SelectamongIR,coloranddualimageforfacerecognitionalgorithm.
Thedefaultvalueisinfrared(IR).
DoorOpenDuration Setthenumberofsecondsadoorremainsopen.
RelayType Selectthedesiredrelayconnectiontype(selectNCorNO).
Relay SelectEnabledforrelaycontrol.
Inthecaseofmealcountmode,disabletherelay.
Language Setthelanguage(selectbetweenKoreanandEnglish).
TamperSwitch Thealarmturnsonwhentherearcoverisopened(forunauthorizeduse).
AdminPassword Changetheadministratorpassword(defaultis1234567890).
DefaultSettings Setthesettingvaluestodefault.
RebootDevice Restartthedevice.
2DeviceInitialization
SetUptheDevice
2.1

•Afterdevicesetting,userregistrationfortheinitialadministratorregistrationwillbegin.
•Youmustregisteratleastoneadministratorandyoumayregisteruptofiveadministrators.
•TheadministratorpasswordcanbechangedinDeviceSettings.
•Forsecurityreasons,theadministratorpasswordmustbechangedandmemorizedwhensettingup.
RegistertheInitialAdministrator
2.2
Makesureyourfacestays
withintheguideline.You
mayneedtoadjustyour
positionbymovingtheface
backandforth.
PressGetStartedtoregister
yourface.
45Pleaseremaininyour
positionuntilthestatus
barreaches100%andthe
faceregistrationis
complete.
SelectUserLeveland
Glassesoptionaccordingly.
Forthosewhodonotwear
glasses,selectNotwearing
andpressNext.
Toregisterasan
administratorforthefirst
time,ontheRegisterUser
screen,selectFaceOnly.
12TypetheadministratorID
andpressNext.Youcan
enterlettersandnumbers
fromaminimumof6toa
maximumof11characters.
3
9
6