Caution
• Only connect or disconnect the adapter to USB
Glow Charger when removed from the AC power
supply.
• Only use the provided adapters. Check if the
voltage indicated on the adapters and chargers
matches the local voltage before connecting to the
USB Glow Charger.
• Only use the USB Glow Charger in an upright
position.
• Always remove the plug from the cord when the
USB Glow Charger is not being used.
• Never open the casing of the USB Glow Charger to
prevent electric shock.
One-Year Limited Product Warranty
CyberPower warrants this Charging Station to be
free from defect in material or manufacture for one
year. If a defect results in product failure during its
normal use, CyberPower’s sole responsibility is to
repair or replace (at its sole option) the charging
station. The foregoing limited warranty is the
consumer’s sole and exclusive remedy and excludes
any incidental or consequential damages. Some
states do not allow the exclusion or limitation of
incidental and consequential damages, so certain of
the above limitations or exclusions may not apply to
you (the Consumer).
This limited warranty gives specific legal rights; the
consumer may have other rights which vary from
state to state. To make a limited warranty claim:
1. Pack and ship the charging station with a dated
Proof-of-Purchase receipt to CyberPower at 4241
12th Ave E., STE 400, Shakopee, MN 55379.
2. Clearly indicate on the outside of the packaging
that this is a WARRANTY RETURN.
3. Clearly include your name and address
(a) On the outside packaging and
(b) On a sheet of paper enclosed in the box with
the charging station that is being returned.
4. You MUST prepay all shipping costs and you are
responsible for packaging and shipment.
CyberPower will inspect and examine the charging
station. If the charging station is defective in material
or workmanship, CyberPower will repair or replace it
and return it to you at CyberPower’s expense at the
place you have indicated. Feel free to contact our
Tech Support department with installation,
troubleshooting, or general product questions. Cyber Power Systems (USA), Inc.
www.cyberpowersystems.com
K01-0000637-01
CyberPower Technical Support
Phone: 1-877-297-6937
Email: tech@cpsww.com
Web: www.cyberpowersystems.com
Address: 4241 12th Ave. E., STE 400, Shakopee,
MN 55379
Hours of Operation: Monday – Friday,
7:00am – 6:00pm (CST)
Conformance Approvals
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference,
and (2) this device must accept any interference
received, including interference that may cause
undesired operation.
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful
interference in a residential installation. This
equipment generates uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there
is no guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment
o and on, the user is encouraged to try to correct
the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
• Connect the equipment into an outlet on a circuit
dierent from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV
technician for help.
Warning: Changes or modifications to this unit not
expressly approved by the party responsible for
compliance could void the user’s authority to
operate the equipment.
