CyberPower P0821UA1-AU User manual

Copyright © 2016 Cyber Power Systems, Inc. All rights reserved.
CONGRATULATIONS ON YOUR PURCHASE
Thank you for selecting the CyberPower 8-Outlet Surge
Protector. The information contained in this manual
explains the features and operation of the product.
Please take a few moments to read this manual.
FEATURES
1. ON/OFF Switch
Controls power to all outlets.
2. Circuit Breaker Switch
To provide output overload and fault protection. It is a
10A breaker. When an overload occurs, it will
shut-down automatically. To resume operation, ensure
the overload condition is removed and reset the surge
protector by switching the unit Reset.
3. Grounded LED Indicator
Illuminated when a properly grounded AC outlet is
detected.
4. Protected LED Indicator
Illuminated when the surge protection feature is
working properly.
5. Standard Spaced Outlets (8)
6. USB Charging Ports*
Connect and charge up to two (2) USB devices using
the surge protected USB powering ports.
*USB outlets cannot be used as a USB hub. This device
does not transfer data
SPECIFICATIONS
• Part Number: CPSURGE08USB-ANZ
• Model Number: P0821UA1-AU
• Outlets: 8 Standard Spaced Outlets
• Electrical Rating: 240V/10A/50Hz/2400W
• USB Charger Rating: 5V/2.4A total
• Surge Protection: 2750 Joules
L-N: 1550 Joules, L-E: 600 Joules, N-E: 600 Joules
• Maximum Spike Current: 67,500A
• 3 AC Lines Protected: L-N: 37,500A, L-E: 15,000A, N-E:
15,000A; (The maximum surge possible on household
wiring is 6,000 volts)
• Maximum Spike Voltage: 6000V
• Response Time: Less than 1 nanosecond
• Circuit Breaker: Resettable 10 Amp
• EMI/RFI Filtration: 150 kHz to 100 MHz
• Attenuation: up to 32dB
CAUTION
TO REDUCE THE RISK OF ELECTRIC SHOCK - Use only
in dry locations and only indoors. DO NOT plug into
another re-locatable power strip. DO NOT “daisy chain”
surge protectors. DO NOT replace the supply cord. If the
cord is damaged, the equipment should be scrapped. DO
NOT use with any aquarium equipment. DO NOT use if
properly grounded outlets are not available. This device
features an internal protection that will disconnect the
surge protective component at the end of its useful life,
but will maintain power to the load – now unprotected.
TROUBLESHOOTING
If the load of surge protector is over 10 Amp, the Circuit
Breaker Switch may have tripped. Please examine your
connected equipment and remove the device that is
overloading the circuit. Then, push the Button of Circuit
Breaker Switch, reset the circuit breaker.
If the Grounded indicator does not light when you plug in
the surge protector, move the surge protector to a
dierent grounded three-prong AC outlet. If it still does
not light, return the product to the dealer for assistance.
If the surge protector proves to be working properly, your
outlets may not be properly grounded and need to be
repaired by a professional electrician.
If the Grounded indicator turns o after a period of use,
the surge protection has been depleted. Replace your
surge protector.
If the Protected indicator does not light, the surge
protector’s AC line is no longer protected from surges.
Replace the surge protector. The surge protector may
have received a power
surge or spike beyond its specified limits that might
overload the protection circuitry and make it inactive.
The surge protector absorbed enough of the surge to
protect your connected equipment, but it will not protect
against future surges and spikes.
ProtectedGrounded
USB Charger 2.4A
USER’S MANUAL
8-Outlet Surge Protector
P0821UA1-AU
8-Outlet Surge Protector
P0821UA1-AU
1
34
5
6
5
2
1 2

WARRANTY
LIMITED WARRANTY AND CONNECTED
EQUIPMENT GUARANTEE
Read the following terms and conditions carefully before
using the CyberPower CPSURGE08USB-ANZ/
P0821UA1-AU (the “CPS Product”). By using the CPS
Product, you consent to be bound by the terms and
conditions of this Limited Warranty and Connected
Equipment Guarantee (together referred to as this
“Warranty”).
IF YOU DO NOT AGREE TO THE TERMS AND
CONDITIONS OF THIS WARRANTY, YOU SHOULD
RETURN THE PRODUCT FOR A FULL REFUND PRIOR TO
USING IT
Who is providing this Warranty, what does it cover?
Cyber Power Systems, Inc. (“CyberPower”) provides this
Limited Warranty. It only covers the original purchaser and
ends if you no longer own the CPS Product. This warranty
covers defects in materials and workmanship in the CPS
Product under normal use and conditions. It also covers
equipment connected to the CPS Product and damaged
because of the failure of the CPS Product. This warranty
covers the CPS Product and connected equipment for as
long as you own the CPS Product.
What must I do to make a warranty claim?
1. Contact CyperPower, mail address is
[e-mail].
2. Identify the Product, the Purchase Date, and the item(s)
of Connected Equipment.
3. Provide a dated Proof-of-Purchase receipt (or other
proof of the original purchase) and provide a
description of the defect.
4. Pack and ship the product to CyberPower and, if
requested, the item(s) of Connected Equipment, and all
claim forms that CyberPower provides to you. Show the
Claim Number on the shipping label or include it with
the product. You must prepay all shipping costs, you
are responsible for packaging and shipment, and you
must pay the cost of the repair estimate.
5. Do each of these within ten days of the occurrence.
What will CyberPower do to correct problems?
CyberPower will inspect and examine the CPS Product. If
the CPS Product is defective in material or workmanship,
CyberPower will repair or replace it at CyberPower’s
expense, or CyberPower will refund the full purchase price
you paid for the CPS Product (purchase receipt showing
price paid is required). If the CPS Product failed to protect
any equipment plugged into it, we will also send you
forms for making your claim for the connected equipment.
We will repair or replace the equipment that was
damaged because of the failure of the CPS Product or
pay you the fair market value (NOT REPLACEMENT
COST) of the equipment at of the time of the damage.
We will use another third-party valuation guide or other
sources to establish that amount. Our maximum liability
is limited to $50,000 for the CPSURGE08USB-ANZ/
P0821UA1-AU.
Who pays for shipping?
We pay when we send items to you; you pay when you
send items to us.
What are some things this Warranty does not cover?
1. THIS WARRANTY DOES NOT COVER ANY SOFTWARE
THAT WAS DAMAGED OR NEEDS TO BE REPLACED
DUE TO THE FAILURE OF THE CPS PRODUCT OR ANY
DATA THAT IS LOST AS A RESULT OF THE FAILURE
OR THE RESTORATION OF DATA OR RECORDS, OR
THE REINSTALLATION OF SOFTWARE.
2. This Warranty does not cover: misuse, modification,
operation or storage outside environmental limits of
the CPS Product or the equipment connected to it, or
for damage while in transit or in storage, nor if there
has been improper operation or maintenance, or use
with items not designed or intended for use with the
CPS Product, such as laser printers, appliances,
aquariums, medical or life support devices, etc.
What are the other limitations?
The sole and exclusive remedies of the Initial Customer
are those provided by this Warranty.
1. This Warranty does not apply unless the CPS Product
and the connected equipment were connected to
properly wired and grounded outlets (including
compliance with electrical and safety codes of the
most current electrical code), without the use of any
adapters or other connectors.
2. The CPS Product must have been plugged directly into
the power source and the equipment connected to the
CPS Product must be directly connected in the CPS
Product, not “daisy-chained” together in serial fashion
with any extension cords, another Product or device
similar to the CPS Product, surge suppressor, or power
tap. Any such installation voids the Warranty.
3. The CPS Product and connected equipment must have
been used properly in a suitable and proper
environment, in conformance with any applicable
license, instruction manual, or warnings.
4. The CPS Product must have been used at all times
plugged into it, within the limitations on the CPS
Product’s VA capacity.
This device is manufactured using environmentally-
safe procedures in compliance with the Restriction of
Hazardous Substances (RoHS) directive.
Please join CyberPower in caring for the
environment by recycling this manual.
CyberPower Australia
E-mail: [e-mail]
Website: www.cyberpower.com
K01-0000559-00
3 4