K01-1101089-00
CAUTION
TO REDUCE THE RISK OF ELECTRIC SHOCK - Use only
in dry locations and only indoors. DO NOT plug into
another relocatable power tap. DO NOT “daisy chain”
surge protectors. DO NOT use with any aquarium
equipment. DO NOT use if properly grounded outlets
are not available. DO NOT install this device if there is
less than 10 meters (30 feet) or more of wire between
the electrical outlet and electrical service panel. DO NOT
use for medical or life support equipment. This device
features an internal protection that will disconnect the
surge protective component at the end of its useful life,
but it will maintain unprotected power to the load.
TROUBLESHOOTING
▪If the protected indicator does not light, the surge
protector’s AC lines are no longer protected from surge.
The surge protector may have received a power surge
or spike beyond its specified limits that overloaded the
protection circuitry and rendered it inactive. The surge
protector has protected your connected equipment as
designed, but it will not protect against future surges,
and spikes. It should be replaced.
▪If the grounded indicator does not light when you plug
in the surge protector, move the surge protector to a
dierent grounded three-prong AC outlet. If it still does
not light, return the product to the retailer for
assistance. If the surge protector appears to be working
properly, your outlets may not be properly grounded
and need to be repaired by a professional electrician. If
the grounded indicator turns o after a period of use,
the surge protection has been depleted. Replace your
surge protector.
TECHNICAL SUPPORT
Please contact our Tech Support Department with
installation, troubleshooting, or general product questions.
• Phone: 1-877-297-6937
• Email: tech@cpsww.com
• Hours of Operation: Monday – Friday
7:00am – 6:00pm CST
LIFETIME LIMITED WARRANTY
$150,000 Connected Equipment Guarantee
For warranty and connected equipment guarantee
information, please visit CyberPowerSystems.com
PRODUCT REGISTRATION
Prompt product registration assures coverage under the
limited warranty, and also allows the opportunity of
notifications for product enhancements, upgrades, and
other announcements.
Registration is quick and easy. Go to the Product
Registration Page at
CyberPowerSystems.com/registration.
CONTACT INFORMATION
Cyber Power Systems (USA), Inc.
4241 12th Avenue East, Suite 400
Shakopee, MN 55379
Toll-free: 1-877-297-6937 | CyberPowerSystems.com This device is manufactured using environmentally-safe
procedures in compliance with the Restriction of Hazardous
Substances (RoHS) directive.
Please join CyberPower in caring for the environment by recycling.
WARNING: This product can expose you to chemicals including Styrene,
which are known to the State of California to cause cancer, and Bisphenol A
(BPA), which are known to the State of California to cause birth defects or
other reproductive harm.
For more information, go to www.P65Warnings.ca.gov.
CONFORMANCE APPROVALS
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference,
and (2) this device must accept any interference
received, including interference that may cause
undesired operation.
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful
interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the
instructions, may cause harmful interference to
radio communications.
However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does
cause harmful interference to radio or television
reception, which can be determined by turning the
equipment o" and on, the user is encouraged to try to
correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment
and receiver.
• Connect the equipment into an outlet on a circuit
dierent from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV
technician for help.
WARNING: Changes or modifications not expressly
approved by the party responsible for compliance could
void the user's authority to operate the equipment.
UL Listed to U.S. and Canadian Safety Standards UL 1449. This
product is listed to applicable U.S. and Canadian safety standards
by Underwriters Laboratories Inc.
