Cypress EZ-USB NX2LP-Flex CY3686 User manual

CY3686 EZ-USB®NX2LP-Flex™ DEVELOPMENT KIT
QUICK START GUIDE
Unpack the kit contents. Using the CD/DVD
provided in the kit, install the kit contents and
Keil uVision IDE.
Set the switches on the FX2LP base board.
SW2 is set to the EEPROM position and
SW1 is set to the large EEPROM position.
Ensure jumpers J3-J14 and J16 are enabled,
write protect switch SW1 is in the OFF position,
and the NX2LP IC pad U1 is unpopulated.
Stack up the FX2LP base board, the
prototype board (optional), and the NX2LP
flex board. Connect it to the host PC. The
device enumerates as a removable drive
in 'My Computer'. Try transferring data to
and from the drive.
1
2
3
4

© 2012 Cypress Semiconductor Corporation. All rights reserved. All trademarks or registered trademarks referenced herein are the properties of
their respective owners. DOC#: 001-81965 REV **
www.cypress.com/go/CY3686
For the latest information about this kit visit
CY3686 EZ-USB®NX2LP-Flex™ DEVELOPMENT KIT
QUICK START GUIDE
CY3686 NX2LP Flex Board Details
Header 1
Header 2
Header 3
LEDs
NAND Flash Chip jumpers for
enable/disable
Header 4
Header 5
Write Protect
Switch
Header 6
NAND Flash
Chips’ Power
3.3 V Power
Pad U1 for
NX2LP-Flex
Pad U2 for
EEPROM