Cypress PSoC 3 User manual

PSoC® 3 DEVELOPMENT KIT
QUICK START GUIDE
Remove the PSoC 3 Development Kit from
the package.
Plug the LCD Module into port P8.
Plug the USB cable into your PC and the
USB communications port (J2).
Vary the R56 potentiometer. The voltage is
displayed with 16 bits of precision on the
LCD module.
Insert the PSoC 3 Development Kit CD.
Install PSoC Creator and the kit software.
Launch PSoC Creator.
Open the code examples from the Start page.
1
2
3
4
5
6

© 2011 Cypress Semiconductor Corporation. All rights reserved. All trademarks or registered trademarks
referenced herein are the properties of their respective owners. Doc. #: 001-60904 Rev. *A
http://www.cypress.com/go/CY8CKIT-030
For the latest information about this kit, visit
PSoC 3 DEVELOPMENT KIT
QUICK START GUIDE
PSoC 3 Development Kit Details
Power Adapter
9 V Battery Boost Converter
Input
Communication USB
10-Pin JTAG/SWD/SWO
Debug and Prog Header
On-board
Programming
USB
24 MHz Crystal
Port D
(CapSense/
Miscellaneous
Port)
32 kHz Crystal
Port E
(Analog Port)
Variable
Resistor/
Potentiometer
RS-232
Interface
Character LCD Interface Switches/LEDs Prototyping Area
CapSense
Reset Button