Cypress CY3210-PSOCEVAL1 User manual

CY3210-PSOCEVAL1 EVALUATION KIT
QUICK START GUIDE
Insert the CY3210-PSoCEVAL1 kit CD in
the CD drive of your PC.
Install the kit contents, PSoC Designer,
and PSoC Programmer.
Remove CY3210-PSoCEVAL1 board from
its package.
Connect jumper (shunt) at JP1 and JP2.
Connect the single strand jumper wire
between P01 and VR.
Plug in the MiniProg to the ISSP header
on the CY3210-PSoCEVAL1 board.
Connect the MiniProg to the PC using
the USB cable provided with the kit.
Open PSoC Programmer; click on the
Toggle Power button to power the board.
Vary the potentiometer; the output hex
values are displayed on the LCD module.
1
2
3
4

© 2011 Cypress Semiconductor Corporation. All rights reserved. All trademarks or registered trademarks
referenced herein are the properties of their respective owners. DOC#: 001-66719 REV *B
www.cypress.com/go/CY3210-PSoCEVAL1
For the latest information about this kit visit
CY3210-PSOCEVAL1 EVALUATION KIT
QUICK START GUIDE
CY3210-PSoCEVAL1 Evaluation Kit Details
Character LCD
Interface
Prototyping Area
UART Rx Pin
RS-232 Interface
Power LED
Voltage Regulator
DC Supply Jack
Push Button Switch Potentiometer
(Analog Input)
LCD Contrast
Control
GPIO Expansion Port
Reset Switch
Chip Socket for
PSoC Device
ISSP Programming Header
9-V Battery
Terminals
JP2 connects P27 to UART Tx Pin
JP1 connects P16 to UART Rx Pin
UART Tx Pin
RS-232 Transceiver
Jumper (JP3) to select
Power Option (3.3 V/5 V)
LEDs