Cypress CAPSENSE EXPRESS CY3218-CAPEXP3 User manual

CY3218-CAPEXP3 CAPSENSE®EXPRESS™ EVALUATION KIT
QUICK START GUIDE
Demo#1: CapSense Express Evaluation Board Test
1. Insert the AAA battery.
2. Remove the Jumper from J2.
3. Observe that the Power LED
lights up.
Touch the CapSense Buttons to turn
ON the respective LEDs.
Insert the kit CD and run the CD’s
autorun utility.
Open the guide and install software.
1
2
3
4

© 2009 Cypress Semiconductor Corporation. All rights reserved. All trademarks or registered trademarks
referenced herein are the properties of their respective owners. DOC#: 001-44865 REV *C
www.cypress.com/go/CY3218-CAPEXP3
For the latest information about this kit visit
CY3218-CAPEXP3 CAPSENSE EXPRESS EVALUATION KIT
QUICK START GUIDE
Top View Bottom View
Status LEDs
CapSense Buttons Power Selection Jumper (J2)
Power LED CapSense Express
AAA Battery Holder (J1)
I2C Header (J5)