Dacor Renaissance MRES30 Technical manual

PLANNING
GUIDE
5.12
Specications subject to change without notice. Phone: [phone]www.dacor.com
30 Inch Wide
Renaissance®Electric Range
MRES30
PRODUCT DIMENSIONS - ISO VIEW
35”
(88.9 cm)
5/16” - 1 13/16”
8 mm - 46 mm)
Removable (factory installed)
3” (7.6 cm) side panels
Optional full size side panels
(ARSL30S, ARSR30S)
60” (152.4 cm) long
240 Vac 4 wire
conduit location
Door opened
Range top
23 1/2"
(59.7 cm)
25 5/16"
(64.3 cm)
Rear of control
Panel/oven door
Max. depth
to oven door
handle with
door closed
30"
(76.2 cm)
45 1/4"
(114.9 cm)
PRODUCT DIMENSIONS - TOP VIEW
All tolerances: +1/16”, -0, (+1.6mm, -0) unless otherwise stated
The optional full size side panels are for installation where the side of the
range will not be covered by the cabinet. For the right side panel, order
Dacor part number ARSR30S. Order part number ARSL30S for the left
side.
The above specifications are for reference only. See the product data label
for exact specifications.
For self-rimming cutout dimensions, see the following page.
Document # PG05-005 Revised 10/01/10 Page 1/2
Dedicated Circuit Required Total Connected Load
240 Vac, 60 Hz., 4-wire*, 50 Amp. 12.5 kW (48.2 Amp.)
ELECTRICAL REQUIREMENTS
NOTES:
1. Electrical is located in the right rear corner of the unit.
2. Range is supplied with a 60” (1524 cm) long 240V 4-wire conduit.
WARNING
• Observe all governing codes and ordinances during planning
and installation. Contact your local building department for
further information.
• This appliance must be installed in accordance with the
accompanying installation instructions.
2
36" (91.4 cm) recommended
30" (76.2 cm) min.
30 1/16"
(76.4 cm)
25"
(63.5 cm)
Hood
30" (76.2 cm)
min.* 10" (25.4 cm)
min. to
combustibles
side wall
(both sides)
Vertical to combustible surface from cooktop surface
Non-combustible rear
wall recommended
Electrical locations**
1) Recommeded
2) Alternate
Consult local code for exact location requirements
**
*
1
Top of
finished
counter
18" (45.7 cm)
min.*
13" (33.0 cm)
max.
14”H (35.6 cm) X 10”W (25.4 cm)
FREESTANDING CUTOUT DIMENSIONS

PLANNING
GUIDE
5.13
Specications subject to change without notice. Phone: [phone]www.dacor.com
MRES30
1/4" (6 mm)
min. flat ledge
28 11/16" (72.9 cm) 11/16"
(1.7 cm)
29 5/8" (75.2 cm)
Rear wall
25"
(63.5 cm)
Adjust for backsplash
thickness
13/16" to 4 1/4"
(2.1 - 10.8 cm)
Backsplash
Vertical
non-combustible
surface rear wall
27 13/16"
(70.6 cm)
29 1/4" (74.3 cm)13/32" (1.0 cm)
30 1/16" (76.4 cm)
Countertop overhangs cabinet
10" (25.4 cm) min.
to combustible side
walls above the range
(both sides)
27 7/8" (70.8 cm)
Adjust for backsplash
over 3/4" thick
from 13/16" to 3 13/16"
(2.1 - 9.7 cm)
Backsplash
thicker than
3/4" (1.9 cm)
1/4" (6 mm)
min. flat ledge
Vertical
non-combustible
surface rear wall
2 13/16"
(7.1 cm)
TOP VIEW - SLIDE-IN, SELF-RIMMING INSTALLATION USING 3” SIDE PANELS
WITH BACKGUARD REMOVED
TOP VIEW - DOWNDRAFT ERV30 WITH SLIDE-IN, SELF-RIMMING INSTALLATION USING 3” SIDE PANELS
WITH BACKGUARD REMOVED
All tolerances: +1/16”, -0, (+1.6 mm, -0) unless otherwise stated
Document # PG05-005 Revised 10/01/10 Page 2/2
30 Inch Wide
Renaissance Electric Range