Daisy UltraDome TM S3 Maintenance manual

daisy
pool covers & rollers
Daisy
Saves
Care &
Maintenance
Cover
Installation
Congratulations. Here’s how to look after your Daisy Pool Cover and Roller.
To ensure receipt of the benefit of this warranty,
complete this section upon purchase and retain with
purchase receipt for production upon warranty claim.
Purchased from:
Please note: Solar pool covers are not safety
covers. They are not designed to support people.
Do not swim under the Cover.
This warranty covers the purchaser for defective
material or workmanship on a pro rata basis as set
out below. The manufacturer will repair or replace
the product upon inspection or photo image.
Daisy reserves the right to refuse repeat claims
of the same damage.
The warranty may be void if:
1 The purchaser fails to comply with the
manufactures installation instructions.
2 Exposes the cover rolled or folded to the sun.
3 Subjects the cover to conditions, which result in
tears, cuts or damage.
4 Stores the cover at a temperature above 45
degrees Celsius.
5 Stores the cover in other than complete shade.
6 Allows the chlorine levels to be maintained at a
higher than normal level.
This is a Pro Rata month by month warranty.
This means that Daisy Pool Covers will pay for the
amount of time that you do not achieve from your
Pool Cover (up to the maximum warranty period). It
also means that you must pay for the period of time
during which you have used the product.
Note - This Warranty is not redeemable for
cash, only as a discount on a replacement
cover purchase.
Product Pro-Rata Warranty cover
S3 Series 3
(200um) UltraDome TM 3 Years
S4 Series 4
(300um) UltraDome TM 4 Years
S5 Series 5
(400um) UltraDome TM 5 Years
S8 Series 8
(500um) UltraDome TM 8 Years
ThermoTech
3mm Foam 8 Years
Daisy is Australia’s largest supplier of pool covers and rollers.
Call: 1300 551 811 Fax: [phone]
Daisy
Saves
daisy
pool covers & rollers
www.daisypoolcovers.com.au
Pool Cover Installation
To install your solar pool cover:
1) Lay the cover bubble side to the water.
2) Flatten out all air bubbles so that the cover
sits relatively flat on the water.
3) Using your pool as a template, take
a pair of ordinary household scissors
(the sharper the better!) and with someone
holding the cover in position, cut the
edge of the cover so that it sits flat on the
water with 50 -75 mm rising up the side
of the pool (but not necessary for the top
edge of the pool).
If required, you can:
A) Cut the cover back to waterline,
however, wait 2-3 weeks after initial
cut for it to settle down.
B) Cut two vertical slits in the cover
upturn, either side of your skimmer box,
fold the flap you have created into the
skimmer box, therefore allowing you to hose
debris off the top of the cover into
the skimmer box.
Your Daisy cover is delivered with an
ample margin for trim. In some cases the
excess is sufficient for secondary use and
left for you to use as you see fit.
Because our covers are made of polyethylene
they are category 4 LDPE recyclable.

Folded flap
to roll up
Pool blanket
Roller & Tube
Locate roller at opposite end of extended area - Fold over to roll up.
Tips to Save your Daisy
1) Whenever the cover is rolled up on
the roller, ensure that the overcover is in
place.
2) To prevent damage to your cover,
do not drag the cover over abrasive pool
decking or any sharp surfaces.
3) Excessive temperatures can
damage your cover. Ensure that
your pool does not reach excessive
temperatures.
4) Most dirt and debris can be hosed
orswept into your skimmer box. If you
have a large amount of debris on top
of your cover, a broom or brush can be
used to sweep it into a pile for removal.
Water and a soft brush are all that is
required to remove heavier grime.
5) Before storage your cover should be
thoroughly hosed both sides to remove
any of the pool chemicals.
When storing your solar pool cover, it
can not be subjected to the sun. Store
in a completely covered environment.
6) When rolling up the cover onto
the roller, ensure that it rolls up evenly.
Always use your overcover whenever
your cover is on the roller.
7) Test your water regularly to maintain
correct chlorine levels. Your cover
will deteriorate quicker when you
have excessive chlorine. When super
chlorinating, leave your cover off the
pool for 48 hours. This allows your
chlorine level to come back to normal.
8) Roll your cover over the top of your
roller when using.
9) Fold in any flaps or step areas on
the cover before rolling it up. This will
ensure that you don’t put excessive
force on the cover and allows it to move
easily.
10) When putting the cover back onto
the pool, roll the cover out slightly, fold
one corner over onto itself (to create a
bow effect), pick up the other corner
and walk slowly down the side of your
pool. (see cover image)
11) Do not sit or step on your roller.
If the tube gets bent, it can not be
repaired.
12) Monitor your chemical levels to
maintain correct balance.
13) When using your roller, ensure that
the brakes on the castors are locked.
14) If a storm is imminent, roll up the
cover and store it safely.
OverCover
Once installed cover & roller
are easy to move away.
Every roller comes with a
Free Daisy OverCover.
Right - Overcover used
when cover not on the pool.
ANY pool cover can be ruined in less
than HALF of it’s predicted life span.
95% of all warranty claims are not
caused by product failure, but by owner
abuse, caused by:
A) Leaving a cover rolled up out in the
direct sunlight while off the pool.
OR
B) Having excess chlorine in the pool
(either a little too high over a prolonged
period or a lot too high over a very short
period)
Either of these may
VOID YOUR WARRANTY
To ensure the effective life of your pool
cover please:
1 - Ensure that your chlorine levels
never exceed 3ppm.
(Chlorine is a corrosive agent and
actually wears the cover) and please
do not assume that your salt-water
chlorinator can control chlorine levels in
your water.
TEST YOUR WATER REGULARLY.
2 - Ensure that you take the cover off
(and leave it off for 48 hours) when
super chlorinating.
3 - Never leave the cover folded or
rolled up in the sun. It must be in full
shade. (Not under shade cloth)
This will cause the cover to be damaged
in strips across the cover and will cause
delamination,also the sun and heat will
cause corrosive wear.
4 - Do not cover the blanket with a
tarpaulin or anything other than the
recommended cover type.
This material will reflect the sun’s rays
while many others will absorb them.
5 - When storing the cover ensure
that it has been washed on both
sides with fresh water before storage.
This does not apply if you are replacing
the cover within 24 hours. This prevents
the chlorine residue from burning the
cover.
6 - If you have a roller ensure that
you place the white overcover
(supplied with the roller) over the
cover every time you roll up the
cover, even if the swim is only for 10
minutes, as this is enough time to
destroy the cover.
Overheating on the roller will
cause delamination in strips across
the cover and in extreme cases can
cause the material to become
molten and weld itself to itself
Defective material or workmanship on
a pro-rata basis as set out on the back
page. The manufacturer will repair or
replace the product upon inspection at
their premises.
WITHOUT PROPER CARE