danalock Universal Module V3 User manual

Universal Module V3
www.danalock.com

3
Specications
Operating voltage range 12-24V DC
Max input (at 24V) 100mA
Number of relays 2
Type of relays Potential-free contacts(NO/NC)
Power output +4dBm
Max relay voltage 48V
Wireless communication Bluetooth® 4.2 Low Energy
Bluetooth® range 5 - 10 meters

4 5
Wiring
Set up your Universal module according to this schematic. Use
relay 1 before relay 2 if possible.
Click commands
You can congure the Universal Module via the button found in
the small hole on the module. When you get to the setting you
want, wait for 5 seconds and the Universal Module will react. If you
make a wrong number of clicks, just stop at an unmarked number
of clicks and wait for 5 seconds. The LED will ash red.
Clicks Color Activity
1Green Inclusion mode
This command is for setting up the Universal Module with a smart home gateway
such as Z-Wave or ZigBee (not HomeKit). The Universal Module will respond by
blinking green. Now the module is in ex/inclusion mode and you have 30 seconds to
pair or unpair it with a gateway.
10 Red Reset the Danalock
Deletes all settings and all keys on the Universal Module. The Universal Module will
respond by blinking red.
Ground
Power output: 12-24v DC 1amp
Relay 2: Normally open
Relay 2: Common
Relay 2: Normally closed
Relay 1: Normally open
Relay 1: Common
Relay 1: Normally closed
Power input: 12-24v DC 1amp
Ground

6
LED mode LED color Status indication
3 sec constant white Power on
Constant purple Firmware update activated
Blinking blue light Settings changed
5 sec blinking white light Identify
5 sec constant red Factory reset
5 sec constant green followed by
green blinks Inclusion mode activated
LED signals

www.danalock.com
Danalock International ApS
Gammel Stillingvej 427C
8462 Harlev, DK
[phone]
[email protected]
UMV3-EN-2018/09/14