Dancing Wings DW MINI EAGLE User manual

DW MINI EAGLE INSTRUCTION MANUAL
A Fuselage parts
B1 B2 Wing parts
C1 C2 C3 Fuselage parts
D Tail parts
E inter structure board of the fuselage
F Motor mount
G propeller
H Plastic clips; Servo horns
I ESC
J prop saver
K1 K2 Motor; set screw
L Servo
M Steel wire pushrod
N Carbon sheet
O Triangle wood
P Wood bolt
Q Rubber band
R Foam glue
STANDARD SETUP
Preparation Tool
Speci�ication
Wingspan: 1200mm
Length: 650mm
Flying Weight≈450g
Battery: 3s 800-1500mAh
Motor: 2212 1100kv
Propeller: 8040
ESC: 20A
Servos: 9g*2
Radio≥3CH
Suggested Equipment
AB1 B2
C1
C2 C3
D
B3
B4
EF
GHI
JK L K2
M
NOPQR
ps：Glue is not available for
some countries.
MINI EAGLE
Dancing Wings
EPP
1

DW MINI EAGLE INSTRUCTION MANUAL
01 Apply the foam glue to the side of the wing,glue the
wings together when the glue is damp-dry,and cut off the
spare parts from the B1.
02 Paste the B3 and B4 parts on the leading and trailing
edge as picture below,make sure the wing is smooth.
03 Insert and glue the reinforcement carbon sheet inside
the spare slot on the wing,and paste the small carbon
sheets on the leading and trailing edge.
04 Assemble the fuselage structure reinforcement from E
boards as picture below.
05 Paste the inter reinforcement onto the EPP A board,and
line up the three points marked out.
06 Paste the upper and lower EPP board of the fuselage
C1,C2 and C3,make sure to keep the shape.
07 Assemble the servo and servo arm inside the
fuselage,and paste the triangle wood at the tail.
08 Paste the tail fin on the triangle wood,and make sure
to keep the V-shape.
B1 B2
CUT
B3
B4
line up the three points
C2
C1
C3
How to Assemble
2

DW MINI EAGLE INSTRUCTION MANUAL
09 Assemble and glue the motor mount at the head of
the fuselage.
10 Assemble and fix the motor mount at the bottom of the
motor by screws,assemble the prop saver,finally assemble
the motor at the head of the fuselage and fix by screws.
11 Assemble the plastic clips onto the servo pushrod,insert
the pushrod from the pre-cut hole on the tail through the
fuselage; Assemble the servo horns on the V-shape tail,and
connect with the plastic clips.
12 Connect the other end of the pushrod with the servo
arm.
14 Insert the 2pcs wood bolts into the pre-cut hole on the
fuselage,and fix the wing with rubber band as picture
shown below.
13 Assemble the ESC inside the fuselage,connect with
motor,finally assemble and adjust the electronics.
CUT
3

DW MINI EAGLE INSTRUCTION MANUAL
15 Adjust the C.G. of the plane and test flying.
C.G
70mm
4