D&D Technologies Lokk-Latch LLP SL User manual

TO DISASSEMBLE
Step 1: Unscrew two Philips head screws
and remove Back Plate from Housing.
BACK PLATE
Lokk-Latch LLP SL Re-keying Assembly
External Access Kit (EAK)
HOUSING
Step 2: Remove Button from Housing.
Step 3:
A. Unscrew three Philips head screws and
remove Spring Base from Button.
B. Remove Lock Cylinder.
BUTTON
SPRING BASE
LOCK CYLINDER
A
B
TO ASSEMBLE
Step 1: A. Insert Lock Cylinder into Button.
B. Screw three Philips head screws through
Spring Base and into Button.
SPRING BASE
LOCK CYLINDER
B
A

Step 2: Insert Button into Housing, checking
that Lock Cylinder Face will be at the
bottom when mounted on post.
Step 3: Using two Philips head screws,
screw Back Plate into Housing as shown.
MOUNTING PLATE BODY
Step 2: A. Remove Cartridge Assembly by
pushing face of Lock Cylinder through Body.
CARTRIDGE
ASSEMBLY
LOCK CYLINDER FACE
BACK PLATE
BACK PLATE
TO DISASSEMBLE
Step 1: Unscrew four Philips head screws
and remove Mounting Plate from Body.
Lokk-Latch LLP SL Re-keying Assembly
Latch (LLP SL)

Step 3: Remove Disc and Spring from Lock
Cartridge assembly.
Step 4: A. Un-clip the hook on the Lock
Cartridge and open as shown.
B. Remove Lock Cylinder.
Step 2: Install Spring and Disc into
cartridge.
SPRING
DISC A
B
A
TO ASSEMBLE
Step 1: A. Insert Lock Cylinder back into Lock
Cartridge and re-hook the clip.
B. Lock Tail should be horizontal as shown.
B
LOCK TAIL
SPRING
DISC

Step 3: Insert Lock Cartridge assembly
partly into Body until position as shown (!)
Step 4:
A. Align the Disc with the left side of the
Body.
B. Bend the Spring end down and into slot,
whilst holding the Disc in its position.
Step 6: A. Check Disc alignment.
B. Push Cartridge Assembly fully into Body.
A
B
Step 5. Check that Spring is as shown (!)
BODY
EDGE OF BODY
!
!A
B

Step 7: Check that the face of the Lock
Cylinder is flush with outer Body and not at
an angle.
Step 8: Screw Mounting Plate to Body with
four Philips head screws through holes as
shown.
a
MOUNTING PLATE BODY